10
Automatic Switch Off:
The Tower Air Fryer has a built in timer, which will automatically shut off the air fryer when
the timer reaches zero. You can manually switch off the air fryer by pressing the key
until the timer reaches zero.
Preparing For Use:
1. Place the appliance on a stable, horizontal and even surface. Do not place the
appliance onto a non-heat-resistant surface.
2. Pull the cord from the storage compartment located at the bottom of the appliance.
3. Do not fill the fryer with oil or any other liquid.
4. Do not put anything on top of the appliance, as this will disrupt the airflow and the
hot air frying will be affected as a result.
Air Frying:
1. Connect the mains plug into an earthed wall socket.
2. Open the air fryer door.
3. Put the ingredients into the air fryer.
4. Close the air fryer door. The fryer will give off a beeping sound and all the indicators
will light up momentarily.
5. After a few seconds, all of the indicators will go off except for the indicator, which
will remain illuminated to indicate the appliance is turned on but in Standby mode.
Press this key at any time while the fryer is in this mode to bring up the touch control
panel.
Note: If no keys are pressed or selections made after the control panel is lit, the air fryer
will automatically go into standby mode after 90 seconds of inactivity.
6. Determine the required preparation time for your desired ingredients (refer to the
‘Settings’ section below). Use the keys to adjust the cooking time accordingly.
The time will increase or decrease in increments of 1 minute, from 0 up to 60 minutes
Note: Preparation times can be changed or adjusted even while the air fryer is in
operation.
7. Adjust to the required temperature. Refer to the ‘Settings’ section in this chapter to
learn how to determine the right temperature. Use the keys to adjust the
temperature accordingly. The temperature will increase or decrease in increments of
5 degrees, from 30 up to 200 degrees.
Note: The temperature can be adjusted or changed at any time, even while the air fryer is
in operation.
8. Once the correct time and temperature have been set, press the key. The
electric heating tube and fan will begin to work, the and indicators will
illuminate and the timer will begin counting down the remaining cooking time.
Note: Press the key again while the fryer is in operation to pause the cooking cycle. The
fan and electric tube will stop working and the corresponding indicators in the touch
control panel will go out to indicate operation has been paused. Press this key again while
the air fryer is in this state to resume cooking.