JONARD TOOLS SA-90 Series User manual

I have reviewed the provided assembly instructions for the JONARDTOOLS SA-90 SAK-90 Fume Absorber. This document details steps on how to assemble the arm-mounted unit, focusing on proper mounting and power cord routing. I'm ready to answer your questions regarding the assembly process or the features mentioned in the instructions.
What should I refer to for instructions on the SA-90 series?

What should you remove from the SA-9 series Fume Absorber when installing SAK-90?

Where should the power cord be routed when mounting the SA-9 to the U shaped bracket?

134 Marbledale Road, Tuckahoe, NY 10707 | Tel 914.793.0700 | Fax 914.793.4527 | jonard.com

SA-90 SERIES ARM-MOUNTED FUME ABSORBER

SAK-90 CONVERSION KIT

ASSEMBLY INSTRUCTIONS

Congratulations on your purchase of our SA-90/SAK-90 Fume Absorber System. This unit has been tested and

inspected by OK Industries prior to shipment. We appreciate your comments and suggestions. Please feel free to

PLEASE FOLLOW

THESE INSTRUCTIONS:

SA-9

SAK-90

(1) SA-90 SERIES - Please refer to the SA-9 manual

contained in the SA-9 FUME ABSORBER box. OMIT

STEP #1.

(1a) SAK-90Removetheexhaustairdeectorfrom

the rear of your SA-9 series FUME ABSORBER.

(2) Using the thumb-screws provided with the SA-9 mount the SA-9 to the “U” shaped bracket.

IMPORTANT: YOU MUST ROUTE THE POWER CORD BELOW THE “U” SHAPED BRACKET

(3) Use the two cable guides provided to hide the power cord along the outside sections of the arm

assembly. Simply push the guides over one of the arms on the SAK-90.

Be sure to run power cord before pushing guide on to the arm.

(4) Clamp the arm mounting bracket in a suitable location on the workbench, insert the arm

assembly and connect the main power cord.

Downloaded from Arrow.com.