Panduit CT-2300 User manual

Panduit
Brand
Panduit
Model
CT-2300
Type
User manual
1
2A
PLACE LOCATOR ON SCREW
AS SHOWN
4C
POSITION C:
SWING LOCATOR OUT OF WAY
SO SPLICES & WIRE JOINTS
CAN BE CRIMPED IN TOOL
LOCATOR MUST BE IN POSITION
SHOWN IN 4A TO BE PIVOTED.
DO NOT ATTEMPT TO PIVOT LOCATOR
IN POSITION 4B !
4A
POSITION A:
INTENDED FOR DISCONNECTS
SLIDE LOCATOR AS SHOWN
REMOVE SCREW HOLDING UPPER
DIE HALF IN TOOL, AND REPLACE
IT WITH LONG SCREW SUPPLIED
WITH LOCATOR
4B
POSITION B:
INTENDED FOR RINGS/FORKS
SLIDE LOCATOR AS SHOWN
6A
PLACE CONNECTOR AGAINST
LOCATOR AND SQUEEZE TRIGGER
1/2 WAY TO MANUALLY HOLD
CONNECTOR IN CRIMP DIE.
DO NOT PUSH CONNECTOR TOO
HARD AGAINST LOCATOR.
INSERT WIRE INTO CONNECTOR.
7
DEPRESS TRIGGER
COMPLETELY TO ACTIVATE
POWERED, CONTROLLED-CYCLE
CRIMP
WIRE STOPS
6B
LOCATOR INCLUDES WIRE STOPS
FOR PROPER INSERTION OF WIRE INTO
CONNECTOR
3
SECURE LOCATOR WITH SUPPLIED
LOCKING HEX NUT TO
TOOL JAW
TOOL
JAW
TOOL JAW
5
PLACE CONNECTOR IN
CRIMP DIE, MATCHING
COLOR DOT ON DIE POCKET
WITH COLOR
OF CONNECTOR INSULATION
NOTE: LOCATOR COMES FROM FACTORY PROPERLY ASSEMBLED. DO NOT MAKE ANY ADJUSTMENTS TO THE POSITION OF THE SET SCREW
2B
ALIGN EDGE OF POSITIONING
BAR WITH TOOL JAW
Terminal Locator for CT-2300 - CD-550LOC
INSTALLATION INSTRUCTIONS T-PMPI-318-PC
Panduit Corp. 2017
C
www.panduit.com
Page 1 of 1
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
E-mail:
[email protected]
Fax:
708-444-6993
Rev 01
POSITIONING BAR
Downloaded from Arrow.com.
  • Page 1 1

Panduit CT-2300 User manual

Panduit
Brand
Panduit
Model
CT-2300
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents