Included Hardware:
2 - Clamps
2 - 5mm Allen Bolts
4 - Grip Pads
4 - Self-Tapping Screws
1 - Privacy Panel
Tools Required:
Phillips Screwdriver
5mm Allen Wrench*
13mm Wrench*
*
indicates tools included with the
original treadmill desk’s packaging
Privacy Panel
Installation instructions on reverse side
www.LifeSpanFitness.com
Place a rubber bumper into each side
of the mounting bracket and slide the
two halves of the bracket together.
Insert the Allen bolt into the clamp
and gently tighten until roughly a
half-inch gap remains between the
two sides.
The privacy panel is meant to be secured underneath the desktop, opposite the desk’s console.
Installation is most-easily accomplished if the desktop is upside down on a at, stable surface.
Follow these 3 simple steps to complete installation of your privacy panel.
Align one of the mounting brackets
over the pre-drilled holes. Using the
included screws and a screwdriver,
gently screw the bracket into the
desktop. Repeat this process on the
opposite side of the desk.
Being careful to not disrupt the rubber
bumpers, insert the privacy panel into
the clamps, ensuring that the panel is
centered. Using a 5 mm Allen wrench,
gently tighten both bolts to secure the
panel in place.
Installation
1. Attach Clamp
3. Install Panel
To view a video of this installation visit:
www.YouTube.com/LS/PS1000
2. Insert Grip Pad
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Vivo STAND-V002M Assembly Instructions
-
-
Exerpeutic Workfit 1030 Owner's manual
-
Invacare Phoenix User manual
-
EleTab 6543862736 Installation guide
-
-
-
Atdec L-PW Specification
-
-
