Legrand PHDHJU48 Operating instructions
- Category
- Signal cables
- Type
- Operating instructions
This manual is also suitable for
R
125 EUGENE O'NEILL DRIVE
NEW LONDON, CT 06320
TEL: 860-445-3800
FAX: 860-405-2990
WWW.ORTRONICS.COM
PANEL
JACK
SLIDE LOCK
PULL BACK SLIDE LOCK TO STOP. THEN INSERT JACK INTO
PANEL (JACK WILL GO IN ONE WAY ONLY WITH SLIDE
LOCK UP).
ONCE JACK SHOULDERS COME
INTO CONTACT WITH BACKSIDE
OF PANEL, PRESS DOWNWARD.
LABEL BEZEL
JACK ICON POCKET
JACK ICON POCKET
LABEL BEZEL INSTALLATION
HIGH DENSITYJACK INSTALLATION
PUSH ON LABEL BEZEL SO THAT
THE TWO BOSSES ON THE BACK LINE
UP WITH TWO JACK ICON POCKETS, THEN
PRESS INTO PLACE.
PUSH ON SLIDE LOCK UNTIL THE FRONT IS FLUSH
WITH THE JACK FACE.
TITLE:
INSTRUCTION SHEET #:
REV:
ECN #:
SHEET:
DWN BY:
DATE:
HDJ PANEL INSTALLATION INSTRUCTIONS
71601790 01 04319
1 OF 2
RWS
11/17/11
GL
11/21/12
A.M.
11/21/12
R
125 EUGENE O'NEILL DRIVE
NEW LONDON, CT 06320
TEL: 860-445-3800
FAX: 860-405-2990
WWW.ORTRONICS.COM
SIMULATED RACK
SECTION
WITH NUTS PROVIDED ATTACH WIRE
MANAGEMENT BAR TO PANEL BRACKETS.
TIGHTEN NUTS.
NUT
PANEL
BRACKET
WIRE
MANAGEMENT BAR
PANEL
SCREWS
PANEL
SCREWS
WIRE
MANAGEMENT BAR
PANEL MOUNTING INSTALLATION
CABLE MANAGEMENT INSTRUCTIONS (TOP VIEW)
BEND
RADIUS*
* THE MINIMUM CABLE BEND RADIUS IS 4 TIMES THE OUTSIDE CABLE DIAMETER.
HOOK LOOP TIE WRAPS SHOULD BE USED TO ATTACH THE CABLES TO THE WIRE
MANAGEMENT BAR. THE CABLE AT THE EDGE OF THE PATCH PANEL SHOULD BE
ATTACHED TO THE CABLE WHICH HAS ALREADY BEEN TIE WRAPPED TO THE WIRE
MANAGEMENT BAR.
HOOK LOOP TIES
ATTACH PANEL TO RACK WITH
SUPPLIED SCREWS.
TITLE:
INSTRUCTION SHEET #:
REV:
ECN #:
SHEET:
HDJ PANEL INSTALLATION INSTRUCTIONS
71601790 01 04319
PG 2 OF 2
-
1
-
2
Legrand PHDHJU48 Operating instructions
- Category
- Signal cables
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI