Command 17202ES Installation guide

Brand
Command
Model
17202ES
Type
Installation guide

This manual is also suitable for

Command 17202ES is a tool-free hanging solution that allows users to hang frames and other items on walls without damaging the surface. It consists of two strips that are pressed together until they click, and then each pair of strips holds up to 1 lb. To use, clean the wall with rubbing alcohol, separate the strips, and press two strips together until they click. Remove one side of the liners and place each pair of strips on the frame as shown, pressing firmly. Remove the remaining liners and press the frame on the wall, pressing each side firmly for 30 seconds.

Command 17202ES is a tool-free hanging solution that allows users to hang frames and other items on walls without damaging the surface. It consists of two strips that are pressed together until they click, and then each pair of strips holds up to 1 lb. To use, clean the wall with rubbing alcohol, separate the strips, and press two strips together until they click. Remove one side of the liners and place each pair of strips on the frame as shown, pressing firmly. Remove the remaining liners and press the frame on the wall, pressing each side firmly for 30 seconds.

•
Wait 7 days after painting before use
•
Do not apply strips to paper or soft surfaces on frame
•
Remove hanging hardware from back of frame
•
Failure to follow instructions
carefully may cause damage
Espere 7 dias después de pintar para usar. No aplique
las tiras sobre papel o superficies suaves en el marco.
Retire ganchos de metal de la parte posterior del marco.
Si no sigue las instrucciones pueden producirse daños.
17202ES
command.com
APPLY APLICAR
REMOVE RETIRAR
SLO W LY
LENTAMENTE
Clean wall with rubbing alcohol.
Do not use household cleaners.
Limpie la pared con alcohol
isopropil. No ultice limpadores
de uso doméstico.
Separate strips. Press two strips together until
they click. Each pair of strips holds 1 lb.
Separe las tiras. Presione dos tiras juntas hasta
que hagan clic. Cada par de tiras sostiene 450 g.
Remove one side of liners. Place each pair
of strips as shown. Press firmly.
Retire un lado de los protectors. Pegue
cada par de tiras en el marco, como se
muestra en la figura. Presione con firmeza.
Remove remaining liners and
press frame on wall. Press
each side firmly for 30 sec.
Retire los protectores restantes y
presione el marco en la pared.
Presione firmemente a cada lado
por 30 segundos.
To ensure adhesive hold, grab bottom corners
and peel frame from wall. Do not pull straight off.
Press each strip firmly for 30 seconds.
Para garantizar la sujeción adhesiva, agarrar las
esquinas inferiores del marco y jale hacia arriba.
No jale horizontalmente. Presione firmemente a
cada tira por 30 segundos.
Wait 1 hour to reattach frame. Line up frame
with strips on wall and press until each pair
of strips click.
Espere 1 hora para volver a conectar el
marco. Alinear el marco con las tiras en la
pared y presione hasta que cada par de tiras
hagan clic.
Grab bottom corners and peel frame
from wall. Do not pull straight off.
Agarrar las esquinas inferiores del
marco y jale de la pared. No tirar hacia
afuera.
Never pull the strip towards you!
Always pull straight down.
¡Nunca jale la tira hacia usted! Siempre
jale directamente hacia abajo.
Stretch the strip slowly against the
wall at least 6 inches to release.
Estire la tira lentamente contra la pared
por lo menos 15 cm para soltar.
2 3
30
SECONDS
SEGUNDOS
4
30
SECONDS
SEGUNDOS
5
1
FRONT
FRENTE
6
CAUTION: Do not hang over beds or on
wallpaper. Do not hang valuable or
irreplaceable items. Use indoors 50º-105ºF.
Limited Warranty and Limitation of
Liability (for product sold in USA): This
product will be free from manufacturing
defects. If defective, your exclusive remedy
shall be, at 3M's option, product
replacement or refund. 3M will not be liable
for any loss or damage arising from this
product, whether direct, indirect, special,
incidental or consequential.
PRECAUCIÓN: No cuelgue sobre camas o utilice en papel tapiz. No cuelgue artículos valiosos
o irremplazables. Uso en interiores 10º a 40ºC
Garantía limitada y límite de responsabilidad (para
producto vendido en E.U.A.): Este producto no tendrá
defectos de fabricación. Si tiene defectos, su única
solución será, a opción de 3M, el reemplazo del
producto o el reembolso del precio de compra. 3M no
será responsable de ninguna pérdida o daño que se
deriven de este producto, ya sea directos, indirectos,
especiales, fortuitos o resultantes.
1
CLICK!
2
3
Up to
4 lb
Hasta
1,8 kg
BACK Posterior
Up to
2 lb
Hasta
900 g
Place 2/3
from top
Pegue a 2/3
de la parte
superior
  • Page 1 1

Command 17202ES Installation guide

Brand
Command
Model
17202ES
Type
Installation guide
This manual is also suitable for

Command 17202ES is a tool-free hanging solution that allows users to hang frames and other items on walls without damaging the surface. It consists of two strips that are pressed together until they click, and then each pair of strips holds up to 1 lb. To use, clean the wall with rubbing alcohol, separate the strips, and press two strips together until they click. Remove one side of the liners and place each pair of strips on the frame as shown, pressing firmly. Remove the remaining liners and press the frame on the wall, pressing each side firmly for 30 seconds.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents