Wyndham Collection WCS202030SDECXSXXMED Installation guide

Type
Installation guide
WC-2020-30
Installation Guide
0
1
2
3
4
1
2
3
0
0
m
m
"
-
C
H
N
HOW TO ADJUST HINGES (if required)
REQUIRED TOOLS NOT IN BOX
Tape measure
Pencil
Electric Drill
Phillips Screwdriver
Adjustable Wrench
Spirit Level
Silicone sealant
(Not all components may be included, depending upon your purchase)
PACKING LIST
Screws for mirror / 2
Mirror / 1 (may not be
included)
Main Cabinet / 1
Professional installation recommended.
Protect all surfaces from sharp objects,
high heat sources, direct prolonged
sunlight and chemical hazards.
Prior to installation please check received
items against the “Packing List”.
Please report any missing items to your
retailer immediately.
Counter & Sink / 1
Feet / 4
adjust depthadjust laterallyadjust heightremoveinstall
WC-2020-30
Installation Guide
(a)
(b)
(c)
6-8mm
INSTALLATION INSTRUCTIONS
1
Installer must cut appropriately sized hole
in back of cabinet to accomodate existing
placement of hot & cold wall valves & drains.
2
Adjust the adjustable feet according to the
floor.
5
Install the screws into the wall anchors,
leaving enough of the screw exposed to hang
the mirror - approx 1/4” - 1/2”.
6
Remove the handles from inside the cabinet
doors and drawers and reinstall on the
outside. Do not over tighten when reattaching.
3
Install the counter. Seal around the top of the
cabinet with clear silicone sealant. Do not over
apply. Allow to dry 24 hours for proper curing.
Cut hole in back
of cabinet
4
Install the mirror: a)use a pencil to mark the
placement of the screw holes on the wall,
b)drill holes, c)insert the plastic wall anchors.
  • Page 1 1
  • Page 2 2

Wyndham Collection WCS202030SDECXSXXMED Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI