Ashdown After Eight, Five Fifteen, Perfect Ten Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Ashdown After Eight Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
http://www.ashdownmusic.com
Operating
Instructions
After Eight
Perfect Ten
Five Fifteen
#13855 - AE PT FF manual 9/4/03 11:40 am Page 1
Operating Instructions Panel Diagrams
FRONT PANEL
INPUT
A single input jack socket is provided for your instrument.This is a high impedance input designed to
perfectly match the impedance of the pick-ups on a passive bass.It also has sufficient headroom available to
allow active basses to be used.Use the Input Gain control to adjust for the sensitivity of your instrument.
EQ
The EQ has Bass,Mid and Treble tone controls as well as a Deep push switch.
The Deep switch increases the low bass boost as well as reducing the degree of Mid frequencies in the
signal to provide an alternative tonal character.
OUTPUT LEVEL
Use the Output Level control to adjust the playing volume of the amplifier.
HEADPHONES
A Headphone jack socket is provided to allow stereo headphones to be plugged into the amplifier for
silent practice.This cuts out the main speaker when a jack plug is inserted.
EXTERNAL SPEAKER
An External Speaker socket is provided to allow you to use an external speaker cabinet if required.This
cuts out the main speaker when a jack plug is inserted.The external speaker must be a minimum
impedance of 8 Ohms.
REAR PANEL
FUSED MAINS INLET SOCKET
This is for connection of the unit to your countries mains power supply.Please ensure that the type and
rating of mains fuse marked on the rear panel is used when this is replaced.
POWER SWITCH
The power to the unit is turned on with the rear panel power switch.A power LED on the front panel will
light to indicate that the amplifier is switched on.
SPECIFICATIONS
AfterEight PerfectTen FiveFifteen
Output Power 15 Watts RMS 30 Watts RMS 65 Watts RMS
Input Impedance 1 M 1 M 1 M
Input Signal Range 100mV to 10V 100mV to 10V 100mV to 10V
INPUT
GAIN
BASS MIDDLE TREBLE
OUTPUT
LEVEL
INSTRUMENT
INPUT
HEAD
PHONES
EXT SPKR
8 OHMS
POWER
DEEP
MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX
ONIN/OUT
After Eight
15
15
w
w
AAAshdownshdownshdown
DesignDesignDesign
After Eight
Front Panel
o
I
POWER
OFF ON
50/60Hz
V A.C.
FUSE
RATING
115 V -
T500 mA
230 V -
T315 mA
MAINS INPUT 30V.A 115V @ 260mA
CAUTION
ATTENTION
100V
Designed in England by Ashdown Engineering manufactured in China.
Model No:-
After Eight
Serial No:-
THIS APPARATUS MUST BE EARTHED.
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE REPLACE ONLY
WITH SAME TYPE AND RATING OF FUSE.
UTILISER UN FUSIBLE DE RECHANGE DE
MEME TYPE ET CALIBRE.
TO REDUCE THE RISK OF
FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.
After Eight
Back Panel
INPUT
GAIN
BASS MIDDLE TREBLE
OUTPUT
LEVEL
HEAD
PHONES
EXT SPKR
8 OHMS
POWER
DEEP
MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX
ONIN/OUT
Perfect Ten
30
30
W
W
AshdownAshdownAshdown
DesignDesignDesign
INSTRUMENT
INPUT
Perfect Ten
Front Panel
o
I
POWER
OFF ON
50/60Hz
V A.C.
FUSE
RATING
115 V -
T1A
230 V -
T500 mA
MAINS INPUT 60V A 115V @ 520mA
100V
CAUTION
ATTENTION
THIS APPARATUS MUST BE EARTHED.
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE REPLACE ONLY
WITH SAME TYPE AND RATING OF FUSE.
UTILISER UN FUSIBLE DE RECHANGE DE
MEME TYPE ET CALIBRE.
TO REDUCE THE RISK OF
FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.
Designed in England by Ashdown Engineering manufactured in China.
Model No:-
Perfect Ten
Serial No:-
Perfect Ten
Back Panel
INPUT
GAIN
BASS MIDDLE TREBLE
OUTPUT
LEVEL
HEAD
PHONES
EXT SPKR
8 OHMS
POWER
DEEP
MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX
ONIN/OUT
INSTRUMENT
INPUT
Five Fifteen
65
65
w
w
AAAshdownshdownshdown
DesignDesignDesign
Five Fifteen
Front Panel
POWER
OFF ON
50/60Hz
V A.C.
FUSE
RATING
115 V -
T1A
230 V -
T500 mA
MAINS INPUT 100V A 115V @ 900mA
100V
CAUTION
ATTENTION
THIS APPARATUS MUST BE EARTHED.
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE REPLACE ONLY
WITH SAME TYPE AND RATING OF FUSE.
UTILISER UN FUSIBLE DE RECHANGE DE
MEME TYPE ET CALIBRE.
TO REDUCE THE RISK OF
FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.
Serial No:-
Designed in England by Ashdown Engineering manufactured in China.
Model No:-
Five Fifteen
o
I
Five Fifteen
Back Panel
#13855 - AE PT FF manual 9/4/03 11:40 am Page 3
/