Atlona AT-GAIN-NET User manual

Atlona
Brand
Atlona
Model
AT-GAIN-NET
Type
User manual
1
Installation Guide
AT-GAIN-NET
Dante / AES67 Network Card for AT-GAIN-120
AT-GAIN-NET
The Atlona AT-GAIN-NET is an audio interface card for the Gain 120 (AT-GAIN-120) amplier.
It features an AES67 and Dante™ dual-channel audio bridge, adding the capability to accept two
channels over a network from Atlona OmniStream™ AV encoders, as well as a Dante or AES67-
equipped DSP. The AT-GAIN-NET easily installs into the I/O expansion slot of the Gain 120.
1 x AT-GAIN-NET
1 x Face plate
1 x Installation Guide
Package Contents
2
Installation Guide
AT-GAIN-NET
Network Card Installation
1. Disconnect the power cord from AT-GAIN-120.
2. Set the AT-GAIN-120 on a at surface, free of obstructions. Position the AT-GAIN-120 as
shown in the picture below.
3. Using a small Phillips-head screwdriver, remove the two screws holding the faceplate in
place. After the faceplate is removed, set it aside. Keep the two screws to attach the
included faceplate with the INPUT card.
WARNING: To prevent the risk of electrocution or electric shock, always
disconnect the power cord from the AT-GAIN-120 before installing or
removing the AT-GAIN-NET network card.
LAN
RESET RESET
LINE OUT
CLASS 2 WIRING CLASS 2 WIRING
TRIGGER MODE
MODEL:
dB
-22
-2
-4
-20
-19
-14
-9
-22
-2
-4
-20
-19
-14
-9
dB
ANALOG IN
L
4 / 8 Ω OUT 70V / 100V OUT
AT-GAIN-120
PWR: 100-120VAC 60Hz 120W
220-240VAC 50Hz 120W
L R
IP
4Ω
8Ω 100V
70V
R
INPUT GAIN
L R
L R
LAN
RESET RESET
LINE OUT
CLASS 2 WIRING CLASS 2 WIRING
TRIGGER MODE
MODEL:
dB
-22
-2
-4
-20
-19
-14
-9
-22
-2
-4
-20
-19
-14
-9
dB
ANALOG IN
L
4 / 8 Ω OUT 70V / 100V OUT
AT-GAIN-120
PWR: 100-120VAC 60Hz 120W
220-240VAC 50Hz 120W
L R
IP
4Ω
8Ω 100V
70V
R
INPUT GAIN
LAN
RESET RESET
LINE OUT
CLASS 2
TRIGGER
ANALOG IN
L
4 / 8 Ω
L R
IP
R
3
Installation Guide
AT-GAIN-NET
4. Locate the plastic guides on either side of the expansion slot.
5. Carefully position the card between the upper and lower rail of each guide, and gently push
the AT-GAIN-NET network card forward, until it locks in place. The card will make a small
snapping sound, once the card is in place.
IMPORTANT: When handling the card, avoid touching the components.
Always hold the card by the edges. Electrostatic discharge can damage
components and the card.
L R
LAN
RESET RESET
LINE OUT
CLASS 2 WIRING CLASS 2 WIRING
TRIGGER MODE
MODEL:
dB
-22
-2
-4
-20
-19
-14
-9
-22
-2
-4
-20
-19
-14
-9
dB
ANALOG IN
L
4 / 8 Ω OUT 70V / 100V OUT
AT-GAIN-120
PWR: 100-120VAC 60Hz 120W
220-240VAC 50Hz 120W
L R
IP
4Ω
8Ω 100V
70V
R
INPUT GAIN
L R
LAN
RESET RESET
LINE OUT
CLASS 2 WIRING CLASS 2 WIRING
TRIGGER MODE
MODEL:
dB
-22
-2
-4
-20
-19
-14
-9
-22
-2
-4
-20
-19
-14
-9
dB
ANALOG IN
L
4 / 8 Ω OUT 70V / 100V OUT
AT-GAIN-120
PWR: 100-120VAC 60Hz 120W
220-240VAC 50Hz 120W
L R
IP
4Ω
8Ω 100V
70V
R
INPUT GAIN
4
Installation Guide
AT-GAIN-NET
© 2018 Atlona Inc. All rights reserved. “Atlona” and the Atlona logo are registered trademarks of Atlona Inc. All other brand names and trademarks or registered
trademarks are the property of their respective owners. Pricing, specications and availability subject to change without notice. Actual products, product images, and
online product images may vary from images shown here.
atlona.com • 408.962.0515 • 877.536.3976
6. Locate the included AT-GAIN-NET faceplate with the INPUT port and install the faceplate
using the screws from Step 2, as shown below. Do not over-tighten the screws using high-
torque devices, as this may cause damage to the screws or the faceplate assembly.
7. Card installation is complete.
8. Connect the power cable to the AT-GAIN-120.
9. Connect an Ethernet cable, with an encoded digital audio stream, to the INPUT port.
Refer to the AT-GAIN-120 User Manual for information on conguring the network card.
Version 2
L R
LAN
RESET RESET
LINE OUT
CLASS 2 WIRING CLASS 2 WIRING
TRIGGER MODE
MODEL:
dB
-22
-2
-4
-20
-19
-14
-9
-22
-2
-4
-20
-19
-14
-9
dB
ANALOG IN
L
4 / 8 Ω OUT 70V / 100V OUT
AT-GAIN-120
PWR: 100-120VAC 60Hz 120W
220-240VAC 50Hz 120W
L R
IP
4Ω
8Ω 100V
70V
R
INPUT GAIN
INPUT
NETWORK AUDIO
LAN
INPUT
NETWORK AUDIO
RESET RESET
LINE OUT
CLASS 2 WIRING CLASS 2 WIRING
TRIGGER MODE
MODEL:
dB
-22
-2
-4
-20
-19
-14
-9
-22
-2
-4
-20
-19
-14
-9
dB
ANALOG IN
L
4 / 8 Ω OUT 70V / 100V OUT
AT-GAIN-120
PWR: 100-120VAC 60Hz 120W
220-240VAC 50Hz 120W
L R
IP
4Ω
8Ω 100V
70V
R
INPUT GAIN
L R
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Atlona AT-GAIN-NET User manual

Atlona
Brand
Atlona
Model
AT-GAIN-NET
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents