Anchor Ring Installation Instructions
1. Clean bottom of anchor ring and surface to be
attached with alcohol pad (included).
2. Cover bottom of anchor ring evenly with super glue
(included).
3. Press anchor ring firmly to prepared surface for
approximately 30 seconds.
Allow glue to cure for 2 hours before using!
4. Your anchor ring is now ready to sue. You may
either feed the security cable through the anchor
ring (see A1) or anchor the security cable by
threading it through the loop.
Anchor Ring - e anchor ring can be attached to a
multitude of devices including printers, monitors,
computers and more.
Note: After installation, the anchor ring cannot be
removed.
A1
Anchor Ring Installation Instructions
1. Clean bottom of anchor ring and surface to be
attached with alcohol pad (included).
2. Cover bottom of anchor ring evenly with super glue
(included).
3. Press anchor ring firmly to prepared surface for
approximately 30 seconds.
Allow glue to cure for 2 hours before using!
4. Your anchor ring is now ready to sue. You may
either feed the security cable through the anchor
ring (see A1) or anchor the security cable by
threading it through the loop.
Anchor Ring - e anchor ring can be attached to a
multitude of devices including printers, monitors,
computers and more.
Note: After installation, the anchor ring cannot be
removed.
A1