20
GB
Disposal of your product
To minimise the risk of injury to children please
dispose of your product carefully and safely.
Remove all doors and lids. Remove the mains cable
(where fitted) by cutting off flush with the appliance
and always ensure that no plug is left in a condition
where it could be connected to the electricity
supply.
To help the environment, Local Authority instructions
should be followed for the disposal of your product.
Disposal of old electrical appliances
The European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances
must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be
collected separately in order to optimise the
recovery and recycling of the materials they contain
and reduce the impact on human health and the
environment.
The crossed out "wheeled bin" symbol on the
product reminds you of your obligation, that when
you dispose of the appliance it must be separately
collected.
Consumers should contact their local authority or
retailer for information concerning the correct
disposal of their old appliance.
Care and Cleaning
CLEANING THE DOORS
(model: 50HEP, DSC50S)
Take particular care not to damage the innerTake particular care not to damage the inner
Take particular care not to damage the innerTake particular care not to damage the inner
Take particular care not to damage the inner
surface of the door inner glass that is coatedsurface of the door inner glass that is coated
surface of the door inner glass that is coatedsurface of the door inner glass that is coated
surface of the door inner glass that is coated
with a heat reflective layer. Do not usewith a heat reflective layer. Do not use
with a heat reflective layer. Do not usewith a heat reflective layer. Do not use
with a heat reflective layer. Do not use
scouring pads, or abrasive powder,which willscouring pads, or abrasive powder,which will
scouring pads, or abrasive powder,which willscouring pads, or abrasive powder,which will
scouring pads, or abrasive powder,which will
scratch the glass. Ensure that the glassscratch the glass. Ensure that the glass
scratch the glass. Ensure that the glassscratch the glass. Ensure that the glass
scratch the glass. Ensure that the glass
panel is not subjected to any sharppanel is not subjected to any sharp
panel is not subjected to any sharppanel is not subjected to any sharp
panel is not subjected to any sharp
mechanical blows.mechanical blows.
mechanical blows.mechanical blows.
mechanical blows.
Stubborn stains can be removed by using a fine
steel wool soap pad. For slight soiling theinner glass
panel may be cleaned, while still warm, without
removing it from the door. Aftercleaning, rinse and
dry with a soft cloth.
SIDE OPENING DOORS
Cleaning the door glass is the same as theCleaning the door glass is the same as the
Cleaning the door glass is the same as theCleaning the door glass is the same as the
Cleaning the door glass is the same as the
drop down doors, except take care todrop down doors, except take care to
drop down doors, except take care todrop down doors, except take care to
drop down doors, except take care to
support the weight of the inner glass whensupport the weight of the inner glass when
support the weight of the inner glass whensupport the weight of the inner glass when
support the weight of the inner glass when
removing and refitting.removing and refitting.
removing and refitting.removing and refitting.
removing and refitting.
DROP DOWN DOORS
Wipe over the outer door glass panels with a cloth
wrung out in warm soapy water, then after wiping
with a cloth wrung out in clear water, dry with a soft
clean cloth.
Ensure that glass doors are notEnsure that glass doors are not
Ensure that glass doors are notEnsure that glass doors are not
Ensure that glass doors are not
subjected to any sharp mechanical blows.subjected to any sharp mechanical blows.
subjected to any sharp mechanical blows.subjected to any sharp mechanical blows.
subjected to any sharp mechanical blows.
Glass Inner Door Panel (where fitted) Glass Inner Door Panel (where fitted)
Glass Inner Door Panel (where fitted) Glass Inner Door Panel (where fitted)
Glass Inner Door Panel (where fitted) – open
the door fully and unscrew the two screws securing
the glass panel, taking care not to allow the glass to
fall. The glass panel may now be washed at the
sink. Stubborn stains can be removed by using a
fine steel wool soap pad.
Ensure the glass panelEnsure the glass panel
Ensure the glass panelEnsure the glass panel
Ensure the glass panel
is not subjected to any sharp mechanicalis not subjected to any sharp mechanical
is not subjected to any sharp mechanicalis not subjected to any sharp mechanical
is not subjected to any sharp mechanical
blows. blows.
blows. blows.
blows. Take particular care not to damage the inner
surface which is coated with a heat reflective layer.
After cleaning, rinse and dry with a soft cloth. For
slight soiling the inner glass panel may be cleaned,
while still warm, without removing it from the door.
Warning: Oven must not be operated with inner door
glass removed.
Take care Take care
Take care Take care
Take care during cleaning not to damage or distort
the door seals. Do not lift the door seal from the
oven chassis, if necessary remove the seal by
carefully unhooking the corner clips.
Take care Take care
Take care Take care
Take care that the rating label edges are not lifted
during cleaning, and furthermore that the lettering is
not blurred or removed.
Oven Lamp Replacement
Open the oven door and remove the rod shelves.
Using a suitable cloth to protect the fingers grip the
light glass dome, unscrew anti-clockwise and lift.
Reach into the aperture with fingers, and unscrew
the lamp anticlockwise. Fit replacement lamp (25W
300°C rated SES), refit dome.
WARNING: To avoid electric shocks - pleaseWARNING: To avoid electric shocks - please
WARNING: To avoid electric shocks - pleaseWARNING: To avoid electric shocks - please
WARNING: To avoid electric shocks - please
ensure that the electricity supply to theensure that the electricity supply to the
ensure that the electricity supply to theensure that the electricity supply to the
ensure that the electricity supply to the
appliance is switched off and the applianceappliance is switched off and the appliance
appliance is switched off and the applianceappliance is switched off and the appliance
appliance is switched off and the appliance
is fully cold, before removing the lamp lens.is fully cold, before removing the lamp lens.
is fully cold, before removing the lamp lens.is fully cold, before removing the lamp lens.
is fully cold, before removing the lamp lens.