![](//vs1.manuzoid.com/store/data-gzf/30e7ae87942717f9e859c44dea383081/2/001600226.htmlex.zip/bg6.jpg)
Contents
Programming Guide HP Hybrid POS Printer with MICR II
v
Apply margin message mode (ColorPOS®) .................................................................................................. 70
Shade and store logo (ColorPOS®) ................................................................................................................... 71
Logo print with knife cut ..................................................................................................................................... 71
Set temporary max target speed ..................................................................................................................... 72
Set LogoEZ® colorization .................................................................................................................................... 72
Set LogoEZ® attribute mapping ....................................................................................................................... 75
Convert 6-dots/mm bitmap to 8-dots/mm bitmap .................................................................................. 76
Enable constant speed logos ............................................................................................................................ 77
Status ............................................................................................................................................. 77
Status command introduction .......................................................................................................................... 77
Batch mode ................................................................................................................................... 77
Transmit peripheral device status (RS-232C printers only) ..................................................................... 78
Transmit paper sensor status ............................................................................................................................ 78
Transmit printer ID ................................................................................................................................................ 79
Transmit printer ID, remote diagnostics extension ................................................................................... 80
Transmit status ....................................................................................................................................................... 83
Send printer software version ........................................................................................................................... 86
Real time commands .................................................................................................................... 86
Preferred implementation .................................................................................................................................. 86
Alternate implementation ..................................................................................................................................86
Rules for using real time commands .............................................................................................................. 87
Moving data through the buer ...................................................................................................................... 87
Busy line and fault conditions ........................................................................................................................... 87
Real time status transmission ............................................................................................................................ 88
Real time request to printer ............................................................................................................................... 90
Real time printer status transmission ............................................................................................................. 91
Real time commands disabled.......................................................................................................................... 91
Automatic Status Back ................................................................................................................. 92
Enable/disable Automatic Status Back (ASB) ............................................................................................... 92
Unsolicited status mode .............................................................................................................. 95
Select or cancel unsolicited status mode (USM) ........................................................................................ 95
Recognizing data from the printer .................................................................................................................. 98
Bar codes ....................................................................................................................................... 99
QR code Overview ................................................................................................................................................. 99
Select model for QR code .................................................................................................................................. 99
Set size for QR code module ............................................................................................................................. 99
Set data parsing mode for QR Code ............................................................................................................... 100
Select error correction level for QR Code ..................................................................................................... 100
Store symbol data for QR Code ........................................................................................................................ 100
Print symbol data for QR code .......................................................................................................................... 101
Transmit QR code print size ............................................................................................................................... 102
Select printing position of HRI characters .................................................................................................... 103
Select pitch of HRI characters ............................................................................................................................ 104
Select bar code height ......................................................................................................................................... 104
Print bar code .......................................................................................................................................................... 104
Print multiple barcodes ....................................................................................................................................... 106
Print GS1 DataBar, null terminated .................................................................................................................. 107
Print GS1 DataBar, data length specied ...................................................................................................... 107
Set GS1 DataBar parameters .............................................................................................................................. 108