ALLEGION VON DUPRIN XP99 Series Installation guide

ALLEGION
Brand
ALLEGION
Model
VON DUPRIN XP99 Series
Type
Installation guide

This manual is also suitable for

*911007-00*
911007-00
Center Case Replacement Kit Less Cover
XP98/99
Installation Instructions
Continue with step 4 on other side of sheet
Slide mechanism case back 6”.
Replace center case.
A. Remove two center case mounting screws.
B. Remove retaining ring and pin.
C. Remove old XP98/99 center case.
D. Attach new center case with new pin,
retaining ring and screws.
Trim
Remove exit device from door.
Two new
mounting screws
New retaining ring
and pin
New XP
center case
Pin must go in front
hole as shown
Remove two screws
and bracket
Slide mechanism
case back 6”
PARTS INCLUDED IN KIT
#8-18 x 3/8” Center Case Cover Screws (Bronze)
#8-18 x 3/8” Center Case Cover Screws (Stainless)
#8-18 x 3/8” Center Case Cover Screws (Brass)
#8-18 x 3/8” Center Case Cover Screws (Dark Bronze)
Retaining Ring
Control Link Pin
Center case assembly
#8-32 x 3/8” Mounting Screws
909 Strike Kit
A
B
C
E
D
Item # QTY Description
4
A
4
4
4
B 1
C 1
D 1
E 2
F 1
Exit device
New retaining ring and pin must be
installed securely. If pin comes out,
door will not open properly.
WARNING
!
CAUTION
!
This is a center case replacement kit for existing XP98/99 devices only. A different kit is required for retrofitting an XP98/99 center case
onto a standard 98/99 Rim device. That kit includes the XP98/99 center case plus additional required parts which this kit does not have.
F
1
2
3
7
6
When properly adjusted, secure
strike with additional screw.
IMPORTANT!
Perform operational check.
B. With door closed, push device pushbar.
Device should allow door to open.
A. With door closed, push against
door without touching device.
Device should NOT allow door to open.
C. If device does not function as described,
adjust strike position and continue
operational check until device functions
as described above.
Strike plate
4
Install new strike using existing
strike holes.
909 Strike
Strike Body
(against door)
5
Verify gap between latch bolt and
strike and adjust strike as needed.
Strike MUST have some gap
Gap
(no more than 3/16”)
IMPORTANT!
© Allegion 2014
Printed in U.S.A.
911007-00 Rev. 01/14-b
Customer Service
1-877-671-7011 www.allegion.com/us
  • Page 1 1
  • Page 2 2

ALLEGION VON DUPRIN XP99 Series Installation guide

ALLEGION
Brand
ALLEGION
Model
VON DUPRIN XP99 Series
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents