Fig.3
www.SereneLifeHome.com
5
Press the ON/OFF Button on the Control. The display will illuminate, the all icon
will displayed for 1.5 seconds.
4. “105°F” will display, indicating the Control
is set at the lowest heat setting, “60m” will
display, indicating the Control is set at the
60 min auto o (see Fig. 3).
WARNING:
Burns can occur regardless of the control setting. Check skin under Pad frequently.
5. To change the heat setting, press the “+” Button for a
higher heat level or the “-” Button for a lower heat level.
The desired heat level and the heat mode icon will
appear for about 3 seconds, and then display the real-
time temperature of the pad. (see Fig. 4).
6. Display of Settings, display as 6 setting, display as 3
setting.
NOTE: If the Control shuts o, make sure the Pad and Control connectors are
securely connected and re-start the product by pressing “ ”.
7. Place the Pad on top of the body. If the Pad does not evenly heat, make sure
there are no folds or bunched up areas.
8. Turn the product o by pressing the Button and unplug it when it is not in use.
AUTO OFF FUNCTION
This product willturn o after a set duration of time.
Settings are 0.5 hour (30 minutes), 1.0 hour and 1.5 hours (90 minutes).
WARNING: Burns can occur regardless of the control setting; check skin under
Pad frequently. Unplug the product when it is not in use.
1. After turning the Pad on and selecting the desired heat setting
(steps 4 and 5 above), press the “ ” Button or the “ ” Button
until the desired amount of time is displayed. The display will
illuminate the desired amount of time (for example “60m”),
Time numerical display ickers for 3 seconds, and then the
desired time setting will display steadily (see Fig. 5).
Fig.4
Fig.5