Sharper Image Pop-Up Christmas Tree Owner's manual

PRE-LIT POP-UP TREE ASSEMBLY INSTRUCTION SHEET

Before you start to setup your tree, please read this instruction sheet carefully.

WARNING -Risk of fire, personal injury and electrical shock.

1. Do not leave product unattended while plugged in.

2. For indoor use only.

3. Replace any missing or broken bulbs before plugging in.

4. Do not place near gas or electric heaters, radiators, fireplaces, candles, outdoor heaters, barbecues or other similar sources of heat.

5. Place on a level, hard, flat surface: do not place wheretree is likely to wobble due to uneven floors or thick carpeting.

6. After assembling the tree and adding decorations, make sure the tree is stable. If tree is not stable, shift the weight of the decorations, and

use support wires to walls and/or window frames (make sure they are secure also).

7. Do not install near fountains, bathtubs, sinks, pools, hot tubs or other wet areas.

8. Do not use candles on this tree.

9. Do not overload extension cords, power strips, or any other power receptacles. Make sure that the electrical rating of the tree and any

other device connected to the same receptacle is below the maximum rating of the extension cord, power strip or other power receptacle.

10. This is an electrical product – not a toy! To avoid risk of fire, burns, personal injury and electrical shock it should not be played with or

placed where small children and pets can reach it.

ASSEMBLY INSTRUCTIONS

WARNING--- Risk of personal injury and electric shock: Watch for any bulbs that may have broken during shipment and replace following the

bulb replacement instruction before plugging in. Please see the lights instruction sheet and replace the bulbs.

1. Insert 4legs into center piece

2. Insert tubes as shown.

3. Insert spigot into bottom of pole.

4. Let tree fall around pole to make tree shape（see the below pictures）.

5. The beginning and the end of the two lamps are connected(see picture 5) And connect the plug to a power supply.

6. Your tree is ready to be decorated and enjoyed.

(picture 5)

7. If the lights are not outwards:

Unplug the power supply. You can with your hands break to outwards.

Customer Service

If you have any questions about your Pop-Up Christmas Tree, please call our customer service department at 1 (877) 714-7444 and

select Option 3.

MADE IN CHINA

Page 1 of 1