Aries 207003-2 Installation guide

Category
Wall & ceiling mounts accessories
Type
Installation guide

This manual is also suitable for

Page1 of 2
Step One: Locate Hardware kit. Check contents with hardware listed below.
NO. NAME QTY REMARKS NO. NAME QTY REMARKS
1
SIDE BARLEFT 1
11
HEX NUT 4 M12
2
SIDE BARRIGHT
1
12
T-BOLT C 2
M10×35
3
FRONT BRACKETLEFT
1
13
HEX NUT 4 M10
4
FRONT BRACKETRIGHT 1
14
SPRING WASHER 8 10mm
5
REAR BRACKETLEFT 1
15
FLAT WASHER 12 10mm
6
REAR BRACKETRIGHT
1
16
HEX BOLT 4
M10×30
7
HEX BOLT 2
M12×35
17
HEX NUT 4 M10
8
FLAT WASHER 6 12mm
18
PLASTIC PIECE 4 M12
9
SPRING WASHER 6 12mm
19
T-BOLT B 2
M10×35
10
T-BOLT A 4
M12×35
Step Two: Remove the front body mount plastic covers(pic 1).
Step Three: Place the front bolt B plate through the body as shown in pic 2. Attach front
support bracket as shown in pic 2.
7
8
9
10
11
12
13
14
15
16
17
18
19
1
2
3
4
5
6
PARTS PIC
Part # 207003 / 207003-2
2007-10 Hyundai Santa Fe
Installation Instructions
Part # 207003 / 207003-2
2007-10 Hyundai Santa Fe
Installation Instructions
Page2 of 2
Step Four: Place the rear bolt plate through the body as shown in pic 3. Attach rear
support bracket as shown in pic 4 .
Step Five: Loosely attach the side bars to the brackets(pic 5).
Step Six: After checking to make sure the side bars are level and parallel with the sides
of the vehicle completely tighten all hardware.
Step Seven: Repeat steps three, four , five ,six and seven on opposite side.
Step Eight: Periodically check and retighten the hardware as necessary.
PIC 1 PIC 2
Plastic covers Plastic covers
PIC 3 PIC 4
PIC 5
Front Rear
14
15
16
17
7
8
9
8
9
10
11
18
12
13
14
15
Through
Rear bracket(right)
Front bracket(right)
13
14
15
19
  • Page 1 1
  • Page 2 2

Aries 207003-2 Installation guide

Category
Wall & ceiling mounts accessories
Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI