Aries 207003, 207003-2 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Aries 207003 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Page1 of 2
Step One: Locate Hardware kit. Check contents with hardware listed below.
NO. NAME QTY REMARKS NO. NAME QTY REMARKS
1
SIDE BARLEFT 1
11
HEX NUT 4 M12
2
SIDE BARRIGHT
1
12
T-BOLT C 2
M10×35
3
FRONT BRACKETLEFT
1
13
HEX NUT 4 M10
4
FRONT BRACKETRIGHT 1
14
SPRING WASHER 8 10mm
5
REAR BRACKETLEFT 1
15
FLAT WASHER 12 10mm
6
REAR BRACKETRIGHT
1
16
HEX BOLT 4
M10×30
7
HEX BOLT 2
M12×35
17
HEX NUT 4 M10
8
FLAT WASHER 6 12mm
18
PLASTIC PIECE 4 M12
9
SPRING WASHER 6 12mm
19
T-BOLT B 2
M10×35
10
T-BOLT A 4
M12×35
Step Two: Remove the front body mount plastic covers(pic 1).
Step Three: Place the front bolt B plate through the body as shown in pic 2. Attach front
support bracket as shown in pic 2.
7
8
9
10
11
12
13
14
15
16
17
18
19
1
2
3
4
5
6
PARTS PIC
Part # 207003 / 207003-2
2007-10 Hyundai Santa Fe
Installation Instructions
Part # 207003 / 207003-2
2007-10 Hyundai Santa Fe
Installation Instructions
Page2 of 2
Step Four: Place the rear bolt plate through the body as shown in pic 3. Attach rear
support bracket as shown in pic 4 .
Step Five: Loosely attach the side bars to the brackets(pic 5).
Step Six: After checking to make sure the side bars are level and parallel with the sides
of the vehicle completely tighten all hardware.
Step Seven: Repeat steps three, four , five ,six and seven on opposite side.
Step Eight: Periodically check and retighten the hardware as necessary.
PIC 1 PIC 2
Plastic covers Plastic covers
PIC 3 PIC 4
PIC 5
Front Rear
14
15
16
17
7
8
9
8
9
10
11
18
12
13
14
15
Through
Rear bracket(right)
Front bracket(right)
13
14
15
19
/