Leviton R50-00617-000 Operating instructions

Category
Motorcycle Accessories
Type
Operating instructions

This manual is also suitable for

Contact Leviton Technical Support at 800-824-3005 (USA ONLY) or visit www.leviton.com for warranty information.
Pour obtenir des renseignements sur les garanties, on peut se rendre au www.leviton.com ou communiquer avec le service de soutien technique de Leviton en composant le 1-800-405-5320 (CANADA SEULEMENT).
© 2017 Leviton Mfg. Co., Inc.
CD-729-00617-31A-W
WARNINGS AND CAUTIONS:
• TO AVOID FIRE, SHOCK, OR DEATH; UNPLUG CORD OR TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE WIRING!
• To be installed and/or used in accordance with appropriate electrical codes and regulations.
Grounding Vinyl Cord Outlet
Sortie de cordon vinyle avec MALT
Rated: 15A-125V
NOTE: Use with Jr. Hard Service Cord, 16/3 to 12/3 AWG, 0.250” to 0.437” dia. COPPER WIRE ONLY!
TO INSTALL:
1. Unscrew both assembly screws.
2. Remove cord jacket and insulation as shown.
WARNING: Do not cut or damage jacket or insulation except as indicated below.
3. Feed cord through body.
4. Connect wires to terminal screws as follows: Black (HOT) to BRASS screw. White (NEUTRAL) to SILVER screw. Green (GROUND) to GREEN screw.
Back out terminal screws until they stop turning (do not force past this point). Twist all copper strands of each wire tightly together. Loop wire clockwise 3/4
turn around screw shaft and tighten screw head securely over loop. Cut off any wire strands not secure under head.
5. Tighten cord clamp firmly.
6. Reassemble the cord outlet.
1 5/8"
1/2"
Copper
Strands
Insulation
Jacket
Round
Cord
WEB VERSION
  • Page 1 1

Leviton R50-00617-000 Operating instructions

Category
Motorcycle Accessories
Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI