ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
41142 42805 41122 43205
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and
all hardware from Junction Box. The junction box is not included.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Take care not to lose any small parts necessary for
installation.
3. Slide the electrical wires through the shade(G)/cover(E)/tube(D)/(C)
/(B) and canopy(A).
4. Raise the pipe of cover(E) to the screw pipe of lamp holder(H), raise
the tube (D)/(C)/(B) and canopy(A) to the screw pipe in order, then
by turning it clockwise until tight.
5. Install the light bulbs(Not included) in accordance with the fixture
specifications. NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE!
6. Thread the two mounting screws into the pre-drilled holes in the
Mounting plate spaced the same distance apart as the holes in the
canopy (A). Attach the Mounting plate to the Junction Box with the
two Junction Box screws as shown. The side of the Mounting plate
marked "GND" must face to out.
7. While holding the fixture lamp towards the ceiling, connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts are
secured. You may have to wrap the connections with electrical tape.
If your outlet has a ground wire (green or bare copper), connect the
fixture ground wire to it. Otherwise connect fixture’s ground wire
directly to the Mounting plate with the green screw provided. After
wires are connected, tuck them carefully inside the Junction Box.
8. Raise the canopy (A) on to the Junction box, aligning screws on
mounting plate with mounting holes in canopy, lock it securely with
the ball nuts. Raise the end grapnel of the crystal(F), hooked the
bottom small hole of the plate.
Your installation is now complete. Return power to the junction box
the fixture.
Mounting plate
Mounting screw
Fixture
Junction Box
(Not include)
Ground
Wire
Ground Wire
41142
41122
42805
43205
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at: 800-761-8056
Or visit us on-line at: WWW.LIVEXLIGHTING.COM
©COPYRIGHT ALL RIGHTS RESERVED.LIVEX LIGHTING,INC. DOC20180841142
FIG.2
FIG.1
-
1
Livex Lighting 41142-91 Operating instructions
- Type
- Operating instructions
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Livex Lighting 60424-91 Operating instructions
-
-
-
-
-
-
-
-
-
Livex Lighting 10513-91 Operating instructions
