Bullet Tools 1901-26-01 Installation guide

Type
Installation guide
STEP 1: With Deck upside down, insert four Item A
screws through the four holes in the Deck. Turn Deck
back over and set on a level surface.
STEP 2: Align the Clamp Assembly
and secure to Deck using the four
screws and four Item B nuts. Do
not over tighten. Cut zip tie after
mounting.
Screws
Deck
Turn Over
ASSEMBLY
*You will need a #3 Phillips head screwdriver
and a 7/16” (11mm) socket or wrench.
Please Review and Verify Parts Included in Box:
HARDWARE KIT:
1. Clamp Assembly
2. Base
3. Knife Kit
4. Hardware Kit
Item A. (4) 1/4”-20 x 1-1/2” PH Phillips Screws
Item B. (4) 1/4”-20 Nuts
A.
B.
Item B
Item A
1
3
4
2
Quick Start Guide
for Magnum Shut-N-Cut #1901-26-01
INSTRUCTIONS FOR USE
Insert knife
in slot
• Pullbackonthered-cappedLockLevertounlocktheClamp
Arm.PivottheClampArmtothefull-openposition.
• SetinsulationonthelowerClampBarsothatthecuttingslot
isin-linewiththedesiredcut.
1
1
2
2
• Close theClamp Arm to compressthe product, pressing
downuntiltheLockLeverengages.
• Insert the EZ Insulation Knife (included) into the cutting
slot on the Clamp Arm.
• Cutthroughtheinsulationproductwithasawingmotion,
drawing the blade toward you.
PRT-INS-1901RevC.5.15©2015BulletTools
For warranty info, accessories, & tips on using and
maintaining your Shut-N-Cut, go to BulletTools.com
Hayden, ID USA • 208-772-0175
Clamp Pressure Adjustment
1) Removethewingnuts.
2)Movethespring-restpinstothedesiredsetting.
For very low pressure, remove the pins completely.
3)Replacethewingnuts.
wingnut
wingnut
SAFETY
1)
SHARP BLADE
- This machine uses
a razor sharp blade.
Keep hands, feet, and other
appendages away at all times.
2) Wear Kevlar™ or cut-resistant
leather gloves when operating or
servicing the blade.
3) This machine has several pinch
points. Do not adjust or collapse
machine when fingers are in the
way.
4) To avoid tipping and/or rocking,
only operate on a level, stable, flat
surface.
5) Wear safety goggles and all other
OSHA recommended safety gear
when cutting.
  • Page 1 1
  • Page 2 2

Bullet Tools 1901-26-01 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI