Gibraltar Building Products JACK6BRN Installation guide

TOTAL JACK™

ADJUSTABLE PITCH

PIPE FLASHING

INSTALLATION GUIDELINES

1. Set TOTAL JACK™ down, flat on the surface of the roof, next

to the pipe you are ventilating. Twist the stack (a) in either

direction to achieve a vertical, upright position. Rotate the

octagonal base flange (b) to fine tune the stack position.

2. Place TOTAL JACK™ over the pipe (a). Adjust base and stack,

if necessary. Rotate the cap (b) to align it with the shingles.

3. Secure octagonal flange with fasteners and caulking as

approved by your local building code. Install remaining shingles in

accordance with manufacturer's specification

CAUTION! Working above grade is inherently

dangerous, be sure that proper fall protection

measures are in place. When working with

power tools, gloves and eye protection are

absolutely required.

For more information and installation video visit: www.totalroofjack.com

These installation guidelines are for use with typical or

standard applications. It is always recommended to seek

advice from a licensed professional, and to check with

your local building inspector or building permit office for

approvals and possible variations that may apply.

TOTAL JACK™ - is the only roof jack with an adjustable cap & turbine base.

This manual is also suitable for

Download PDF