Atlantic Eclipse 444 CD / 200 DVD User manual

Type
User manual

This manual is also suitable for

2 - Screw (L) into panel (A). Insert dowels (M) and plastic inserts (U) into the holes as shown.1 - Insert (K) into side panels (E) and (F). Arrows should point towards screw opening, see diagram (1-A)
3 - Fasten (N) to panel (A) with screws (R). Insert pins (P) into the holes.
4 - Attach (E) and (F) onto panel (A). Lock by turning (K) in side panels (E) and (F), clockwise until it locks.
See diagram (4-A).
U
5 - Slide middle panel (D) into groove in panels (E) and (F).
7 - Attach metal plates (O) to left door (G) and right door (H) with screws (S). 8 - Attach doors (G) and (H) to (A) and (B) with pins (P). Attach base panel (B) to side panels (E) and (F) with screws (Q).
U
6 - Insert dowels (M) into the holes of base panel (B) as shown. Insert plastic inserts (U) and then pins (P) into the
holes as shown.
Hex Key
9 - Fasten rotating bracket (J) onto the lower base (C) with screws (T) using provided tool (Hex Key). 10 - Attach lower rotating base (C) to (B) by inserting and tightening screws (T) through access holes, one at a time.
11 - Insert pins (P) at desired heights. 12 - Place shelves (I) on pins (P).
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Atlantic Eclipse 444 CD / 200 DVD User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI