Kit Installation
CAUTION DISCONNECT UNIT FROM POWER BEFORE
INSTALLATION.
1. Disconnect unit from power.
2. Make sure oven is cool enough to work with.
3. Remove racks and rack slides from unit.
4. Remove (4) screws to remove thermostat assembly.
5. Disconnect terminals that are connected to thermostat. Discard old thermostat assembly.
6. Carefully remove any silicone sealant left on oven surface from step 4.
7. Reconnect terminals to new thermostat assembly (non-polarity).
8. Re-attach thermostat assembly with the 4 screws supplied in kit.
9. Replace rack slides and racks.
10. Turn power on and check for proper operation.
.
WARNING PART REPLACEMENT MUST BE DONE BY
FACTORY- AUTHORIZED SERVICE
TECHNICIAN. IMPROPER INSTALLATION
CAN CAUSE INJURY TO PERSONNEL
AND/OR DAMAGE TO EQUIPMENT.