2. Mantis
  3. 5265

Mantis 5265 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Mantis 5265 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
A - GUARD
B – LOWER PLATE
C - WING NUT
D - FLANGE BOLT
PARTS – No Tools Required
1.
2.
4. 5.
Align holes in guard (A) with slots
in lower plate (B).
Insert flange bolts (D) through lower plate (B)
and guard (A). Place lock washer (E) over
flange bolt (D). Loosely screw on wing nut
(C) and repeat on other side. Do not tighten.
Align assembled guard so it is centered on
tiller fender. Slide assembled guard down
over the tiller fender tab.
Slide lower plate (B) down over tiller fender.
Make sure lower plate (B) is fully extended
over tiller fender.
Holding flange bolt (D) tighten wing
nut (C). Repeat other side.
E - LOCK WASHER
A
B
– MAKE SURE TILLER
IS TURNED OFF PRIOR TO INSTALLATION
3.
Keep lower plate
in back position
6.
7.
Align the dethatcher hub
(F) with the tine shaft and
slide dethatcher accessory
onto tine shaft. Repeat for
other side.
Insert retaining pin (G) into
tine shaft to secure
dethatcher accessory (F).
Repeat on other side.
Right
Left
G – Retaining Pin
F – Dethacher Accessory
Parts – No Tools Required
P/N 410732, 6/11
/