Mantis 5265 Owner's manual

A - GUARD

B – LOWER PLATE

C - WING NUT

D - FLANGE BOLT

PARTS – No Tools Required

4. 5.

Align holes in guard (A) with slots

in lower plate (B).

Insert flange bolts (D) through lower plate (B)

and guard (A). Place lock washer (E) over

flange bolt (D). Loosely screw on wing nut

Align assembled guard so it is centered on

tiller fender. Slide assembled guard down

over the tiller fender tab.

Slide lower plate (B) down over tiller fender.

Make sure lower plate (B) is fully extended

over tiller fender.

Holding flange bolt (D) tighten wing

nut (C). Repeat other side.

E - LOCK WASHER

– MAKE SURE TILLER

IS TURNED OFF PRIOR TO INSTALLATION

Keep lower plate

in back position

Align the dethatcher hub

(F) with the tine shaft and

slide dethatcher accessory

onto tine shaft. Repeat for

other side.

Insert retaining pin (G) into

tine shaft to secure

dethatcher accessory (F).

Repeat on other side.

Right

Left

G – Retaining Pin

F – Dethacher Accessory

Parts – No Tools Required

P/N 410732, 6/11