STA-RITE Intelliboost R Series Quick start guide

Brand: STA-RITE

Model: Intelliboost R Series

Type: Quick start guide

QUICK START GUIDE

Intelliboost

R Series

Risk of electric shock. Can shock, burn or kill.

Risk of issues to be aware of:

• Drive’s internal components retain high voltage for up to 5

minutes after input power is disconnected

NOTICE: See Owner’s Manual for more illustrations and de-

tailed information.

Tank air pressure must be at 70% of the system’s set-point.

Pump Start-Up

The discharge pressure of the pump equals the pressure

produced by the pump plus the pressure on the suction side

of the pump.

Make sure that the suction and discharge shutoff valves are

both open.

When the system is connected to the power supply it

initializes. The green LED will be ON and the Pentair logo

shows up on the display (Figure a). As this initialization ends,

the pump stops and the display shows STOP(Figure b).

(a) (b)

SET

ESC

MODE

LINE

RUN

FAULT

SET

ESC

MODE

LINE

RUN

FAULT

STOP

If you need to change the set-point, wait for the initialization

to complete and then push the up

or down button.

Hold down the button until the desired set-point is displayed.

1. Start the pump by pressing on the ON/OFF

button.

SET

ESC

MODE

LINE

RUN

FAULT

The pump starts and

reaches the pressure

level set at the factory

(default is 60PSI). The

RUN/FAULT LED will be

ON and showing green. If

the system pressure is

equal to or higher than

the factory pressure

setting, the pump will be

in stand-by mode (green

LED ON), ready to start if

the pressure decreases.

2. The pump should start when the pressure drops below

the set-point and pressure should return to the set-point and

stay there. Do not run the pump with the discharge shut-off

valve closed! If the system goes to PROTECTION mode, refer

to the “Quick Troubleshooting Guide”.

Programming

1. Language setting:

To change the language, press the SET button

SET

ESC

MODE

LINE

RUN

FAULT

PRESSURE

PRESSIO

PRESSURE

PRESIÓN

60 PSI

2. Display setting:

Press MODE to change the display configuration and choose

between GRAPHIC (a) and TEXT (b) modes.

MODE

LINE

RUN

FAULT

MODE

LINE

RUN

FAULT

SET

ESC

MODE

LINE

RUN

60 PSI

3. Pressure level setting (set-point):

To increase or decrease the set-point, press the up

down

buttons

(a) (b)

SET

ESC

MODE

LINE

RUN

FAULT

SET

PSI

SET

ESC

MODE

LINE

RUN

FAULT

SET

PSI

293 WRIGHT STREET, DELAVAN, WI 53115 WWW.PUMPS.COM

PH: 888-237-5353 ORDERS FAX: 800-321-8793

STA-RITE Intelliboost R Series Quick start guide

STA-RITE Intelliboost R Series Quick start guide

STA-RITE Intelliboost R Series Quick start guide

Related papers

Other documents