MI.38.M1.02 - VLT
®
is a Danfoss Registered Trademark 1
This instruction sheet is for the installation of a mains shield for the
VLT series drives frames D1, D2 and E1. This kit can be installed in
IP21/NEMA 1 or IP54/NEMA 12 enclosures on D1, D2 frames manu-
factured after week 29 of 2005 and all E1 frames. It is not possible
to install in the IP00/Chassis versions as these have included as
standard a metal cover. These shields satisfy VBG-4 requirements.
Ordering numbers
Frames D1 and D2: 176F0799
Frame E1: 176F1851
INSTRUCTIONS
INSTALLATION OF MAINS SHIELD FOR VLT DRIVES
Required Tools
• Socket wrench with 07mm to
17mm sockets
• T30 Torx Driver
Torque Requirements
M6—35 in-lbs (4.0 N-M)
M8—85 in-lbs (9.8 N-M)
M10—170 in-lbs(19.6 N-M)
IP21 Frame D2 VLT
Mains Shield kit parts
Lexan® cover with
access holes for
test probes and
two mounting
brackets (E1 mains
shield consists of
two pieces )
Install mounting
brackets on the
input plate using
existing studs
and nuts
IP21 Frame D2 VLT
with mains shield
installed
Install mains
shield using
4 M6 torx
screws
-
1
Danfoss VLT AutomationDrive FC 302 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Danfoss VLT® AQUA Drive FC 202 SW 1.33 User guide
-
Danfoss VLT® AutomationDrive User guide
-
-
Danfoss VLT AutomationDrive FC 302 Operating instructions
-
-
-
-
Danfoss VLT® HVAC High Power Oper. Operating instructions
-
-
