2. Delta
  3. 2FT-3FT

Delta 2FT-3FT User manual

  • Hello! I have reviewed the user manual for the Delta Floating Shelf 2FT/3FT. This document provides detailed instructions on how to install the shelf using hollow-wall invisibolts. It also includes important safety information, tool requirements, and steps for proper installation. I'm ready to answer your questions about this product and its installation process.
  • What is the minimum clearance behind the wall required for installation?
    What is the maximum weight the shelf can hold?
    What tools are required for installation?
Slim Floating
Shelf
WARNING
x1 — Floating Shelf
x2 — Hollow-Wall Invisibolt
Parts
A
B
A
Tools Required
1/4" Wrench (6.35mm)
Hand Drill 5/8"(15mm) Bit
Level
B
Do not allow children to play or hang from shelf
Maximum weight on properly installed shelf is 33lbs, 15 KGS evenly distributed.
Assembly instructions (24Hollow-Wall "/36")
Cap
102722
Attach shelves onto brackets, pressing completely against the wall.
1
2
5
6
IMPORTANT SAFETY NOTE
Beware of drilling into electrical wire or pipes within wall!
Use actual shelf back to determine and mark where mounting holes need to be
drilled. Use spirit level to ensure shelf will be horizontal.
Drill 5/8” (15mm) hole. Hold metal channel alongside plastic straps & slide
channel through the hole. Minimum clearance behind wall: only 1-7/8".
3
Hold the ends of straps together between thumb & forenger and pull toward
you until channel rests behind wall. Ratchet cap along straps with other hand
until ange of cap is ush with wall.
4
Place thumb between straps at wall. Push thumb side to side, snapping o
straps level with ange of cap.
Insert Invisibolt bolt through white at washer and tighten until snug, then stop.
Use wrench to tighten securely. Be careful when nding the thread, inserting
the Invisibolt with too much force can push the channel through the wall.
IMPORTANT NOTE
Holes are for positioning, not additional reinfocement.
WALLBOARD
SECURE
INVISIBOLT
™
90º TO WALL
90º
90º
90º
90º
SHELF 2FT/3FT
Alternative hole positions allow for sideways
shelf placement options. Select holes in shelf
to match stud distances (usually 16”).
23
5/8" (600mm) / 35
1
/2" (900mm)
16" (406.5mm)
16" (406.5mm)
1 2
3 4
/