2. iFixit
  3. MacBook Pro
MacBook Pro

iFixit MacBook Pro User manual

  • Hello! I've reviewed the user guide for replacing the lower case of a MacBook Pro 13" Unibody Mid 2010. The document includes clear instructions, a list of tools and parts you'll need, and steps on how to remove the old case and install the new one. I'm here to answer any questions you have about this procedure, so feel free to ask.
  • What tools are needed for the lower case replacement?
    What parts are needed for the lower case replacement?
    How many screws need to be removed?
MacBook Pro 13" Unibody Mid 2010 Lower
Case Replacement
Replace the lower case in your MacBook Pro 13" Unibody Mid 2010.
Written By: Walter Galan
MacBook Pro 13" Unibody Mid 2010 Low…
Draft: 2019-12-17Guide ID: 4315 -
This document was generated on 2022-05-26 12:40:19 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 3
INTRODUCTION
Replace the lower case in your MacBook Pro 13" Unibody Mid 2010.
TOOLS:
Phillips #00 Screwdriver (1)
PARTS:
MacBook Pro 13" Unibody Lower Case
(1)
Macbook Pro Unibody Lower Case
Screw Set (1)
MacBook Pro 13" Unibody (Model A1278
Mid 2009 Mid 2010) Screw Set (1)
MacBook and MacBook Pro Unibody
Plastic Feet (1)
MacBook Pro 13" Unibody Mid 2010 Low…
Draft: 2019-12-17Guide ID: 4315 -
This document was generated on 2022-05-26 12:40:19 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 3
To reassemble your device, follow these instructions in reverse order.
Step 1 — Remove the lower case screws
Remove the following 10 screws
securing the lower case to the
MacBook Pro 13" Unibody:
Seven 3 mm Phillips screws.
Three 13.5 mm Phillips screws.
Step 2 — Lift the lower case away
Slightly lift the lower case and push
it toward the rear of the computer to
free the mounting tabs.
MacBook Pro 13" Unibody Mid 2010 Low…
Draft: 2019-12-17Guide ID: 4315 -
This document was generated on 2022-05-26 12:40:19 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 3
/