MIGRO 160 Series Operating instructions

  • Hello, I've reviewed the user manual for the Migro Wireless Transceiver 160 Series. This document outlines the steps for setting up the frequency on the radio, including using the microphone's keypad. If you have any questions regarding these procedures or any other aspect of this device, please ask away!
  • How do I turn on frequency mode?
    How to select frequency?
    What should I do before applying power to the receiver?
Before you apply power,
1 connect the Antenna,
2 insert the Microphone
3 Power the radio ON
4 On the Microphone keypad click on the A/B button
Move the arrow to the upper section of the display
Key in the frequency by example 1 6 0 1 0 0
Turn the Power OFF
Turn the Power ON
Your selected frequency will appear at the top of the display
Turn the Power OFF
Remove the Microphone.
System is Ready
After the battery is full charged
Turn on the Radio,
Message ”FREQUENCY MODE”
Enter the desired frequency
By Example Key in 1 6 0 1 0 0
Turn OFF the Transceiver
Turn ON the Transceiver
The 160000 is set.
NOTE initial Mode selection
Press and HOLD the Menu button and turn on the Radio
Frequency MODE or “TELL MODE” message will come up,
Repeat the operation to set the radio in
FREQUENCY MODE”
RECEIVER
TRANSCEIVER
Migro Wireless 160 Series Frequency Selection Setup
For information consult the manufacturers Transceiver Manuals
MIC
/