Instructions
MOTORCYCLE LED
H4 WIRE HARNESS
WWW.RETROFITLAB.COM
1. CONNECT TO H4 HEADLIGHT FEED
2. CONNECT TO DRIVER OF LED PROJECTOR
3. CONNECT TO 12v+ SOURCE OF BATTERY
4. CONNECT TO GROUND/CHASSIS OF BIKE
5. CONNECT TO HIGH BEAM CONNECTOR OF LED PROJECTOR
1
2
3
4
5
When using this H4 wireharness with a time delay relay:
In some motorcycles, the combination of the H4 wiring and
the time delay relay doesn’t work properly. When you are
experiencing electrical problems like the motorcycle not
shutting o, please remove the middle pin from the relay,
this should x the problem.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Starline V63 Owner's manual
-
APRILIA ATLANTIC 500 Specification
-
Elmic GT100 User manual
-
MV Agusta Brutale Oro-S Workshop Manual
-
-
Ultra Start MCS-100 User manual
-
-
Onyx RCR V2.0 Owner's manual
-
BMW V.O.I.C.E R 1200 CL User manual
-
