Ortech ODB-100 User manual

Brand: Ortech

Model: ODB-100

Type: User manual

WARNING

Dryer Boxes

MODEL ODB-100

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.

Electrical products can cause death or injury, or damage to property.

If in any doubt about the installation or use of this product, consult a competent electrician.

INSTALLATION GUIDE

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY

A QUALIFIED ELECTRICIAN.

CAUTION

1. These Dryer Boxes are suitable for indoor use only

2. Please keep the Dryer Boxes away from any corrosive substance, and please use dry

cloth when you clean it

3. Dryer Boxes can only be installed by a qualified electrician

4. Before installation or maintenance, please read through this instruction manual

5. Be careful of the Dryer Boxes' sharp edges

Instruction Manual

1-888-543-6473

1-888-541-6474

13376 Comber Way

Surrey BC V3W 5V9

[email protected]

www.ortechindustries.com

375 Admiral Blvd

Mississauga, ON L5T 2N1

IMPORTANT REMINDER

Beware of the SHARP EDGES

Pre-installation

1. Unplug the dryer

2. Shut off the gas

3. Disconnect the vent hose from the dryer

Dryer Box Installation

1. Cut a square investigation hole near the center of the proposed appliance

2. Confirming this installation is possible, mark and cut the final rough opening

3. Using a drywall saw, cut out the hand-drawn inner cutline on the drywall and the original outer

trace line over the baseboard

4. Position the upper end of the Dryer Box into the opening in the wall and align the pipe through the

opening in the top port.

5. Wear leather gloves, and reach through the top port and attempt to guide the pipe through the port opening

6. Once the pipe is through the top port, continue to push the dryer box from the bottom to be flush to the drywall.

7. Use a drywall screw or self-tapping screw to secure the bottom of the dryer box to the bottom plate.

The top is held firmly against the drywall by the pipe's penetration

8. Un-crimp the pipe and make sure it has no burrs or obstructions

9. Caulk the baseboard cuts and any gaps

Ortech ODB-100 User manual

Ortech ODB-100 User manual

Ortech ODB-100 User manual

Related papers

Other documents