QOLSYS IQ Panel 4 Stand Installation guide

Hello! I've reviewed the IQ Panel 4 Stand Quick Install Guide and understand the steps for setting up the stand. This document provides instructions on how to attach the power supply, secure the panel to the SmartMount stand, and route the power cord. I'm here to answer any questions you have about the installation process or the components involved.
What screwdriver is needed for installation?

Where should the power wire be routed?

What should you do with the SmartMount backplate?

IQ PANEL 4 STAND QUICK INSTALL GUIDE

1. With the included power

supply and cable, plug the

barrel connector into the

barrel jack as shown above.

Be sure the barrel connector

properly seated.

1. Locate the SmartMount

table stand and insert the

hooks into the back of the

panel, then swing down

and press into place.

Be sure that the power

wire is routed out the

middle of the table stand

using the provided slot.

1. With a small phillips

screwdriver, screw in the

locking screw from the

bottom of the panel to

secure it to the table stand.

1. With a small phillips

screwdriver, undo the locking

screw from the back of the

panel, remove the SmartMount

backplate and discard.

Do not use for UL2610 or EN Grade 2 or equivalent installations

Document#: IQP4ST-QG-02-22

Qolsys Product #: IQP4STAND-WHT

IQP4 STAND-BLK

GOT QUESTIONS?