Swagelok MS-CRD-FIXTURE Series Operating instructions

MS-CRD-FIXTURE Series

Brand: Swagelok

Model: MS-CRD-FIXTURE Series

Type: Operating instructions

Series 5, 10, and 20 Weld Head Tube Fixture Block

Attaching Centering Gauge to Plenum

1. Attach a

screw

(#4-40 UNC), a lock washer, and

one end of the

lanyard

to the side of the

plenum

with the tapped hole.

2. Use a

screw

(#4-40 UNC) and lock washer to

attach the

centering gauge

to the other end of

the

lanyard

.

Fixture side plates

Plenum

Plenum

Lanyard

Screw

Centering

Centering

gauge

Collets

Cap

Cap

screws

Cap

Cap

Cap

Cap

Cap

Cap

Latch

Series 5, 10, and 20 Weld Head Tube Fixture Block

Alignment Adjustment Instructions

1. Loosen the four

cap screws

on the

ﬁ xture side

plate

pointed to by the arrows on the

plenum

.

2. Place a minimum length of tubing in the

collets

so it rests across both side plates.

Swagelok − TM Swagelok Company July 2005, R0

© 2005 Swagelok Company MS-CRD-FIXTURE

Weld Head Series

Minimum Tubing Length,

in. (mm)

Series 5

1.50 (38.1)

Series 10

2.00 (50.8)

Series 20

3.00 (76.2)

3. Lock down the stationary

ﬁ xture side plate

and

then the loosened

ﬁ xture side plate

using the

latches

at the top of the ﬁ xture side plates.

4. Tighten the four

cap screws

loosened in step 1.

5. Release the latching mechanism, and remove the

straight length of tubing.

1
2

Swagelok MS-CRD-FIXTURE Series Operating instructions

MS-CRD-FIXTURE Series

Brand: Swagelok

Model: MS-CRD-FIXTURE Series

Type: Operating instructions

Download PDF

Other documents