Flaming Oil Diffuser
Owner’s Manual
R2022.10.08
Before operating this unit carefully read the contents of this manual.
Thank you for choosing the Essential Oil Diffuser.
To ensure safety, please read the entire contents of this manual.
Precautions
• The product should be repaired by trained qualied professionals.
• Use caution to ensure you don’t damage the wires of the power
adapter. If the wires are damaged immediately discontinue use.
Do not attempt to repair the wires.
• If there is abnormal heat, smell or the power adapter is not pow-
ering the unit, immediately unplug it from the wall and diffuser and
discontinue use.
• Do not use the power adapter in wet areas and keep away from
water.
• For best results, empty any remaining water from the tank before
relling and wipe the unit dry.
• Keep the mist away from other electronics, furniture, clothes and
walls.
• Place the unit on a hard smooth surface where the fan at the bot-
tom of the unit will not be impeded.
• Do cover the top of the unit where mist is expelled.
• Do operate the diffuser or power adapter with wet hands.
• Keep away from children.
• Do not use the diffuser with an empty water tank.
• Only use 100% pure natural essential oils. Synthetic oils or chem-
icals can damage the diffuser.
• Do not use any corrosives inside the diffuser.
• Don not exceed the mamimum water volume of 180mL.
• Only use the Type C - 2 Amp power cord that came with this dif-
fuser.
• Only use puried water inside the diffuser.
• If you accidentally knock over the diffuser or drip water into the
main body, follow these instructions.
• Unplug the power supply immediately and open the cover.
• Pour all the water out of the tank.
• Shake the diffuser gently, drain any water out of the diffus-
er, and let dry for 24 hours before continuing use. If after
24 hours the diffuser won’t power on or stay on, unplug and
discontinue use.
Instructions for Proper Use
1. Add water into the water tank up to the water level line. Do not
exceed 180mL.
2. Add a desired amount of essentials oils. Just a few drops is
usaully sufcient.
3. Press the atomization button to turn on the diffusing process.
One more press will turn it off.
4. One press on the LED light button will turn on the aming effect.
Press and hold again to increase brightness. One more press
will turn the lights off.
5. If no water is detected the built in protection will automatically
turn the diffuser off.
To view our warranty information, privacy policy and terms and con-
ditions, please visit
https://www.airoasis.com/policies/#warranty-policy.
Warranty
Copyright © 2022 Air Oasis, LLC. All Rights Reserved.
806-373-7788
www.airoasis.com
3401 Airway Blvd.
Amarillo, TX 79118
Specications
Troubleshooting
Model:
OilFD-B, OilFD-W
Dimensions:
6.7” x 3” x 4”
Electrical:
DC 5V, 2A, 4.5W
Weight:
1 lbs
Frequency:
50/60HZ
Materials:
Polymers, electronics
Capacity:
180mL
Limited Warranty:
1 Year
The diffuser quickly turns
itself off after it’s turn on.
Make sure the power adapter is connected.
Make sure you’re using the correct power adapter.
Make sure there is water in the tank.
Abnormal amount of fog
exiting the diffuser.
Make sure there isn’t too little or too much water in
the tank. Do not exceed 180mL.
The diffuser isn’t atomiz-
ing water to create a fog.
Clean the atomizing sheet.
Check to make sure the air outlet below the fan on
the bottom isn’t clogged with dust.
Make sure the shell is properly closed.
Make sure the water is room temperature. Water
that is too hot or cold can have adverse affects.
Images and parameters are for reference only and may vary from actual product
depending on the model. Images and features are subject to change.
/
