WHAT IS IN THE PACKAGE ?
1. Windscreen
2. Bike Mount
3. Base Mount Brackets
4. SS Rods 5. Screen Bracket
6. Handlebar Assembly
9. M6 SS Bolts
X 8 (For Screen)
8. M6 Nyloc Nuts X8
(For Screen)
10. M6 Washers X8 (For Screen)
7. Screen Mount
11. M6 Nyloc Nuts X3 (For Bike Mount)
11. M6 Bolts X2
(For Bike Mount) 12. M6 Long Bolt
(For Bike Mount)
STEP 1:
Stage 1: Shield Mountings
Fix the Screen Mount parts on the
Metal Screen Brackets
using the pre installed bolts
STEP 1:
Stage 1: Shield Mountings
Fix the Screen Mount parts on the
Metal Screen Brackets
using the pre installed bolts
LEFT RIGHT
Make sure the bolt heads are outside
both the sides for later easier accessibility
Add 4 X SS M6 bolts to the front side of the shield
Along with M6 SS Washers over the pre-installed Grommets
STEP 2:
Stage 1: Shield Mountings
STEP 2:
Stage 1: Shield Mountings
Add 4 X SS M6 bolts to the base mounting holes
of the shield along with M6 SS Washers
over the pre-installed Grommets
STEP 3:
Stage 1: Shield Mountings
Install the shield mounting brackets to the windshield
(Do not Over tighten)
STEP 4:
Stage 1: Shield Mountings
Install the Base mounting brackets to the windshield
(Do not Over tighten)
This is how it looks post assembly
STEP 1:
Stage 2: Base Mountings
Align the Bike Mount to the
Base Mount Brackets
(Do not Over tighten)
This hole is the lowest setting. You can use any of these holes
And the slider configuration and get upto 1.5 inch height
and 10 mm backward adjustability and also can adjust
the shield angle by upto 30 degrees.
You can install on the lowest setting first and if needed
you can use other settings and find your best position
STEP 2:
Stage 2: Base Mountings
This is how the assembly looks post
all brackets installation
STEP 1:
Stage 3: Bike Mounting
Install the handlebar assembly along with SS Rods as shown here.
This is the best place to install the assembly
(Don’t Overtighten the bolts)
Make sure the rods are on the outer sides
STEP 2:
Stage 3: Bike Mounting
Insert the windshield assembly
from below the headlight
as shown here
STEP 3:
Stage 3: Bike Mounting
Install the windshield assembly
To the headlight bolt using the spare
long bolt provided in the package
Use the first bolt as it is the sturdiest place.
This is how it looks post installation
Make sure the mounting bolt is installed
in the reverse order as shown here
To avoid touching the headlight
On the shield side, loosen both the side bolts slightly
Align the SS rod head to the designated
shield mount cavity
Press the shield from outside
against the rod head and
make sure it slots in properly
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/