2. BEMIS
  3. E85320ARM 000

BEMIS E85320ARM 000, E85320TSS 000, R05300TSS User manual

  • Hello! I've reviewed the installation instructions for the CLEAN SHIELD seat. This document provides a clear guide on how to install the seat, including the use of the Snap 2 Secure system and the included installation tool. I'm ready to answer any questions you might have about the installation process or the features mentioned in the instructions.
  • How do I install the seat?
    What tool should I use to tighten the seat?
    How do I remove the seat?
    What if I am using support arms?
    What if I am not using support arms?
Check all parts
Revisar todas las partes
1
Place seat on bowl
Coloque el asiento en la taza
2
Gently finger tighten both Snap 2 Secure nuts
Apriete suavemente ambas tuercas "Snap 2 Secure"
• Confirm proper seat alignment on the bowl
• Holding the seat in place, use Installation Tool to tighten
both Installation Heads until they “snap-off”
(Seat Removal: Turn nut clockwise with installation tool)
4
• If you are adding Support Arms, see installation
instructions in Support Arms package
• If not adding Support Arms, slide Caps into holes
• Si está agregando brazos de soporte consulte las instrucciones
de instalación en el paquete de brazos de soporte
• Si no agrega brazos de soporte, deslice las tapas en los orificios
Snap 2 Secure Nuts Installation Tool
BemisIndependence.com
1B5990157A
• Confirme la alineación correcta del asiento en la taza
• Manteniendo el asiento en su lugar, use la herramienta de
instalación para apretar ambos cabezales de instalación
hasta que la parte inferior de la tuerca se desprenda
(Desmontaje del asiento: gire la tuerca en sentido contrario
utilizando la herramienta de instalación)
Installation Instructions: CLEAN SHIELD
™
seat
3
Caps
SNAP!
Bushing
Thrust Washer
Nut
Shear Line
Installation
Head
Installation
Wrench
(Included)
SNAP!
Snap 2 Secure™
System
/