WARNING! Connection of a gas appliance should only be
done by a qualified installer.
E(S)VFIK Vent Free Installation Kit
Make sure you have the following items in your kit:
No. Description Qty.
1. Flexible stainless steel connector (10”)
2. 3/8“ Flare x 3/8” NPT Elbow fitting
3. 3/8“ Flare x 3/8” NPT Straight fitting
4. 3/8“ Flare x 1/2” NPTF Adaptor
5. Thread sealant
This kit is designed to aid in the installation and connection of your gas
appliance.
Use thread sealant only on the NPT (pipe ) threads.
Do not use sealant on the flare threads (the fittings attached to the stainless steel
line).
Follow the instructions provided with your appliance, and follow all local codes. In
absence of local codes, refer to NFPA54 (National Fuel Gas Code).
1
1
1
1
1
Tee Joint
Pipe
Nipple
Cap
3" Minimum
Sediment
Trap
To Appliance Via Either 3/8” \Flare Elbow or 3/8” Flare Straight Fitting
From
Gas Meter
CSA. Design-Certified
Manual Shutoff Valve
With 1/8" NPT Tap*
INCLUDED
Approved Flexible
Stainless Steel Connector (if allowed
by local codes)
Typical Gas Connection
VFIK-IS 2012
INCLUDED
3/8” Flare x 1/2” NPTF Adaptor
NOT INCLUDED
Tested and approved for use with the following models:
BWH10NLM(A)
(394-S-09-5) IWH10NLT(A)(394-S-19b-5) BVFM18NL(394-S-18-5)
BWH20NLM(A)(394-S-10-5) IWH16NLT(A)(394-S-19b-5) MVFT24NL(394-S-18-5)
BWH30NLM(A)(394-S-11-5) IWH26NLT(A)(394-S-1b9-5) VFF23NG/LP(394-S--5)
GWH30NLM(A)(394-S-11-5) VFS26LP/NG (394-S-15-5) VFF26NG/LP(394-S-19-5)
VIWH10/20/30(394-S-19-5) VBWH10/20/30(LT/LM/NT/NM)(394-S-09b-5)
PortlandTested &
Listed By
Oregon USA
/
