Assembly
Assembling the Grapevine Angel
Step1. Align four parts of Lower Dress (D) with each other and fasten them with Plastic Ties (N). Align
the two Support Rods (G) between the left and right sides of the Lower Dress and secure using the
Wingnut (I). (FIG.1)
Step 2. Align two halves of the Upper Dress (C) with each other and fasten them with Plastic Ties. Metal
bars attached are used to stabilize the Upper Dress. Insert the hooked end of the metal bars into the
metal hole on the opposite side of the Upper Dress. (FIG.2)
Step 3. Insert the metal rods attached to Upper Dress (C) into the matching holes on the Lower Dress
(D); at the same time, insert the Support Frame (F) in between the Upper Dress (C) and Lower Dress
(D) then fasten together with Wingnut (I) for secure locking connection. (FIG.2)
Step 4. Align the two parts of Body (A) with each other and fasten them with Plastic Ties (N). Insert the
metal rods attached to the bottom of the Body (A) into the matching holes on the top of the Upper Dress
(C) and fasten together with Wingnut (I) for secure locking connection.(FIG.3)
Step 5. Hang the hooks of each Wing (B) into the matching holes on the body. Insert the rods of
Trumpet (E) into the matching holes in the Angel's mouth. (FIG.3)
Step 6. Wrap the Belt (H) around the Waist of the Angel. (FIG.4 )
Step 7. Hook the plastic end of each of the four Anchoring Strings (J) onto the metal
loop at the waist; put the "U" Shape Stake (K) through the free end of each Anchoring
String then tightly secure to the ground evenly. (FIG.4)
Pre-Operation
CAUTION: Grasp the plug to insert or remove from the power source.
Do not unplug by pulling on cord.
CAUTION: The lighting string on this product is rated at 142.8Watts
(1.19Amps). Do not overload. Do not connect to other lighting strings, decorative
outfit or other electrical products. Before you use or re-use this product inspect it
carefully. Return to Store or discard if the product has cuts, damage or frayed wire
insulation on cords, cracks in the socket enclosures, loose connections or exposed
copper wire.
Care and Cleaning
a. Carefully remove the product from wherever it is placed. This helps to avoid any
undue strain or stress on the product, wire and lighting connections. If the product
is placed somewhere other than the ground it should be well secured and stable.
b. Wipe the unit with a damp cloth and allow the unit to dry before storing.
c. Store the product neatly in a cool, dry location protected from sunlight.
FOR INDOOR AND OUTDOOR USE
F
C
D
G
H
J
K
FIG.1
FIG.2
FIG.3
C
FIG.4