Premier PRT-100 Installation guide

Premier
Brand
Premier
Model
PRT-100
Category
Flat panel wall mounts
Type
Installation guide
Installation Instructions Visit the Premier Mounts website at http://www.mounts.com
PRT-100 VESA Tilting Mount Installation Instructions
9531-037-021-01
Parts List
PRT-100
PRT-100
(Qty 1)
3130 East Miraloma Avenue
Anaheim, CA 92806 USA
USA and Canada
Phone: 1.800.368.9700
Fax: 1.800.832.4888
Other Locations – Phone: (001).714.632.7100; Fax: (001).714.632.1044 ©Premier Mounts 2011
The PRT-100 VESA tilting mount securely holds at-panels up to 32"
in place and provides up to 12° of continuous tilt for optimal viewing.
The at-panel can easily be installed on a wood stud using the mount’s
quick hook-in monitor attachment. A 75x75mm or 100x100mm VESA
at-panel mounting pattern is required.
Step 3
Determine the VESA mounting pattern
for attaching the PRT-100 to the
at-panel.
A = 75x75mm VESA
B = 100x100mm VESA
Step 4
Using the determined VESA mounting
pattern, insert four (4) M4 x 10mm
pan combo screws to attach the
PRT-100 front component to the
at-panel.
If the M4 x 10mm pan combo
screws are not long enough, use
four (4) M4 x 12mm pan combo
screws.
#14 x 2" Wood Screw
(Qty 2)
Step 1
Remove the front component of the
PRT-100 from the back component.
Step 2
Use two (2) 14 x 2” wood screws to
attach the wall plate to a wood stud.
#14 x 2" Wood Screw
M4 x 10mm Pan Combo
Screw (Qty 4)
M4 x 12mm Pan Combo
Screw (Qty 4)
A A
A A
B B
BB
Pan Combo Screws
Page 2 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
PRT-100
Step 5
Attach the front and back components
of the PRT-100.
1) Slide the horizontal rod in the
front component into the upper
slot of the back component
(Figure 1).
2) Rest the bottom hooks of
the front component against
the bottom tabs of the back
component (Figure 2).
Step 6
1) Pre-install two (2) M4 x 10mm
pan combo screws in the left
and right side screw holes of the
PRT-100 (Figure 1).
2) Slide up the front component of
the PRT-100 to the desired tilt
(Figure 2).
The bottom hooks of the
front component should
hook onto the bottom
tabs of the PRT-100.
3) Tighten the side M4 x 10mm pan
combo screws to lock in the tilt.
PRT-100 Installation Instructions (cont’d)
Flat-Panel
Horizontal Rod
Wood stud not shown.
Figure 1
Figure 2
M4 x 10mm Pan
Combo Screw
Figure 1
Figure 2
12°
Hook onto the
tab
Wood stud not shown.
  • Page 1 1
  • Page 2 2

Premier PRT-100 Installation guide

Premier
Brand
Premier
Model
PRT-100
Category
Flat panel wall mounts
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents