Rio Beauty Scanning Laser X60 Owner's manual

Brand: Rio Beauty

Model: Scanning Laser X60

Category: Light depilation

Type: Owner's manual

This manual is also suitable for

LAHC5 Scanning Laser X60

LAHC5

CLASS 1 PRODUCT

CONTAINING

CLASS 3B LASER

808nm

wavelength

Wearing laser

safety goggles is

unnecessary as

the product has

been designed

with inbuilt safety

features.

PATENTS PENDING

This product MUST be used responsibly.

Please read these Instructions carefully

before use.

Refer to your Information Guide for:

• WARNINGS

• SECURITYBUTTONSEQUENCE

• HOWDOLASERSWORK?

• SUITABLESKINTYPES

• PATCHTEST

• HAIRGROWTHCYCLE

• WHYISASERIESOFTREATMENTS

REQUIRED?

• YOURQUESTIONSANSWERED

• TROUBLESHOOTING

™

SALON LASER

SCANNING HAIR REMOVER x60

WARNINGS

• Readallinstructionsthoroughlyandretainforfuturereference.

• NotsuitableforAfro-Caribbean, black skincomplexionsor forGreyHair.

See“SuitableSkinTypes”inInformationGuide.

• Laserhairremovalshouldnotcausediscomfort,youmayfeelindividualhairs

beingtreated,whichislikeamildpinprick,andaslightwarmingofthearea.

Ifyoufeelanydiscomfortorsorenessthesettingmaybetoohigh.

• Inbuiltsafetyfeaturesprotecttheeyebeingexposedtothelaser,however,

neveraimtheWandatorneareyes.

• DoNOTusenearflammablematerials.

• Keeptheproductoutofreachofchildrenandpets.

• ReflectionHazard:Pleaseremovealljewelleryinthevicinityofthetreatment

areabeforeuse.

• Whennotinuse,storethekeyresponsiblyinasafeplaceawayfromchildren.

• Donottreatthesamehairrepeatedlyinanyonesession.

• Donotuseafterdrinkingalcoholorifyouarefeelingunwellorfatigued.

• Donottreatthefollowingareas:tattoos,permanentmake-up,pimples,warts,

haironblackspotsormoles,darkfreckles,skindisease,birthmarks,burns,

lips,nipples,genitaloranalareas,eczema,eyelashes,eyebrows,nearthe

eyes,nasalorearhair.

• Thisisasensitivelaserscanningproduct.Careshouldbetakentoavoid

damagetothemechanismintheWand.

• Thisapplianceisnotintendedforusebypersonswithreducedphysical,

sensoryormentalcapabilities,orlackofexperienceandknowledge,unless

they have been given supervision or instruction concerning use of the

appliancebyapersonresponsiblefortheirsafety.

PRECAUTIONS

• DoNOTdismantleorrepair.Ifyouhaveanyproblemsusingtheproduct,

contactourCustomerCareDepartment.

• Misuseoftheunitcancauseharm.

• DoNOToverrideanysafetyfeaturesoropentheunitorwand.

• OnlyusethisproductwiththeMainsAdaptersupplied.

• KeepWandawayfromstrongelectromagneticfieldsandmagnetsduringuse.

PATCHTEST

IMPORTANT:24hoursbeforetreatmentitisveryimportanttodoapatchtest.

Thepatchtestwillconfirmthemaximumpowerlevelforyourskintype.Eacharea

tobetreatedmustbecheckedasskincolourcanvary.Pleaserefertothe‘PATCH

TEST’sectionintheInformationGuideandontheDVDforinstructions.

Aslightrednessmayoccur,butnotalways,withinanhouroftreatment.This

localisedrednessiscausedbythedestructionofthehairfolliclesandisquite

normal.However,ifanyrednessremainsafter24hoursthiswouldindicatethe

powerlevelselectedwastoohighforyourskintype.

GETTINGSTARTED

Please ensure you read the Information Guide and understand the

‘Warnings’ and ‘Product Safety’ sections before proceeding.

• Shavetheareatobetreated.Thisensuresthatthelasergoesdirectly

tothehairrootandavoidshairburningonthesurface.

• Removealljewelleryinthevicinityofthetreatmentarea.

• Pleaseensureyouhavepatchtestedtheareatobetreated24hours

prior to treatment.

STEP 1

ConnectMainsAdapterintotheDCPowerSocketat

thebackoftheunitandplugintotheMains.

STEP2

Unlock with Key to turn on. The light around the

Keyswitchwillflashgreen.

STEP 3

Enterthe“SECURITYBUTTONSEQUENCE”.

You will find the Security Button Sequence in the

Information Guide.

ThegreenlightaroundtheKeyswitchwillfullyilluminate.

Thelightsaroundthex60SCAN,x20SCANandSINGLE

buttonswillflashbluereadyforselection.Thebottom

PowerLevelIndicatorlightwillilluminate.

STEP4

Usethe+/-buttonstoselectthecorrectpowerlevel

foryourskintype.Refertothe‘PatchTest’sectionof

theInformationGuideforskintypes.

Each time the power setting is adjusted, you will

need to reselect x60 SCAN, x20 SCAN or SINGLE

modetocontinue.

Note:Ifnobuttonsarepressedafter20minutestheUnitwillenterenergy

savingmode.The orangelightwill flashandpower level1 will remainon.

TorestartturnkeyoffandbackonagainandstartatStep3.

ADDITIONALINFORMATION

STEP 8

Turn the Keyswitch anticlockwise to lock the unit.

RemovetheKeytoasafeplaceawayfromchildren.

Note: Ifyouexperienceunexpectedbehaviourofthisproductthenitispossible

someexternalelectromagneticinterferenceisresponsiblee.g.electricmotors/

loudspeakersetc.Youshouldremovethissourceandrestarttheproductto

restorefulloperation.Atnotimewillthelaserfireunintentionally.

‘SINGLE’HAIRTREATMENT

Youcanopttotreatsinglehairsusing

theSINGLEmode.

Press the ‘SINGLE’ button once.

TheSINGLEbuttonwillilluminateblue.

The orange light on the Wand

willilluminate.

FollowthesameprocedureforSCANtreatmentfromStep6,butthistime

pressing the SINGLE button.

InSINGLEmode,thebluelightaroundtheSINGLE

buttonwillflash.

Referto‘TreatmentArea’section,SINGLEmode.

“SECURITY

BUTTON

SEQUENCE”

TREATMENTAREA

Asaguidetothetreatmentarea,asmallindentationmarkwillbeleftby

pressingtheWanddownontheskin.Inx60SCANmode,overlapping

theindentationmarkslightlywhenmovingtheWandineachdirectionwill

ensureeffectivecoverage.Inx20SCANmode,overlaptheindentation

markbyhalf.

SCANmodessequentiallytargetsinglehairsineachtreatment.

SINGLEmodeisfortreatingindividualhairs.Thetreatmentareaisinthe

centreoftheindentationguideandmeasures1mmx1mm.

‘SCAN’HAIRTREATMENT

STEP 5

Press the x60 SCAN button once. The

blue light around the button will fully

illuminate.Theorangelightonthewand

willilluminate.

Alternatively,pressthex20SCANbuttononce.

STEP6

Placethewandontheskinovertheareayouwishtotreat,

ensuringtheTouchPinsareincontactwiththeskin.

TheorangelightwillturnOFFandthewhite‘ready’light

willturnON.

ThebluelightsaroundtheSCANbuttonwillrotateto

indicatetreatmentisreadytostart.

STEP 7

Press and HOLD the Laser Button on the top of the

wandtostartlasertreatment.

The white light will flash on and off to indicate laser

treatmentisinprogressandtheunitwillbeeprepeatedly

(thiscanbemuted).Youwillnotbeabletoseethelaser.

You may feel individual hairs being treated, whichis

likeamildpinprick,andaslightwarmingofthearea

beingtreated.

Whenthelasertreatmentceases,theorangelightwill

comebackon.Youcannowmoveontothenextareaof

hairstobetreated.

Whenmovingthewandtothenextareaofhairstobe

treatedtheTouchPinsmustberemovedbrieflyfrom

theskin.

Refertoscanmodesin‘treatmentarea’section.

IMPORTANTNOTES - please read carefully

• DoNOTmovethewandduringtreatment.Youmaynoticethewandbecomes

warmduringusethisisquitenormal.

• IfcontactislostbetweentheTouchPinsandskinduringtreatment,thewand’s

orangelightwillcomeon.Treatmentwillresumewhencontactismadeagain.

• Foryoursafety,ifthewandisnotpositionedcorrectlyontheskinsurfacefor

treatment,thewhiteandorangelightswillflashalternatelyandoperationof

thelaserwillbedisabled.

• Sometimesyou cansmell faint burningor even seea very, smallline of

smokeasthehairistreated.

• Successfullytreatedhairsdonotalwaysfalloutimmediately,butareshed

over time as they are released from the hair follicle, light rubbing can

encouragethis.

• Youmayfeela‘pinprick’sensationduringtreatment.Anylocalisedrednessafter

treatmentiscausedbythedestructionofthehairfolliclesandisquitenormal.If

anyrednessremainsafter24hoursthiswouldindicatethepowerlevelselected

wastoohighforyourskintype.Pleaserefertothe‘PatchTest’sectioninthe

InformationGuide.Anylongerlastingrednesswillalsodisappear.

LASERHAIRTREATMENT

PresstheMUTEbuttononthebackoftheUnittoturn

offtheBeepnoises.Pressagaintoturnbackon.

Note: Thisdoesn’tturnoffwarningbleeps.

resettingafter‘lockout’

If you experience a ‘lockout’ as indicated by

repeatedflashingofanyofthebluepowerlights,

simplyresetbyturningtheunitoffusingthekey,

waiting5secondsandturningtheunitonagain.

cleaninglaseraperture

Periodically check whether there are any smoke

deposits on the Laser Aperture. A build up of

depositswillaffecttheefficiencyofthelaser.Ifyou

noticeanydeposits,switchtheunitOFFandunplug

themainsadapter.Thensimplycleanwithalintfree

clothorcottonbud,ensuringnofibresareleftinthe

LaserAperture.

x60 SCANmode

x20SCANmode

SINGLEmode

Rio,Dezac,SalonLaserScanningHairRemoverx60andLaserSafeTechnologyaretrademarksofTheDezacGroupLtd©TheDezacGroupLtd2011anufacturedbyTheDezacGroupLtd,POBox17,Cheltenham,EnglandGL537ET

Overlapbyathird

Overlapbyhalf

treatmentarea

indentationmark

treatmentarea

indentationmark

treatmentarea

indentationmark

1-IN-LAHC5-UK/1.2

instructions