Page is loading ...
How to use Http and Ftp provision
Get the http provisioning packet from Welltech and start the provisioning as follows:
Step 1: build mac list for mass configuration file generation
Please open the “LP389 MAC.csv” gotten from Welltecg by using Microsoft Excel, you can refer the
picture below. Normally, you should get all required configuration mac list from Welltech and use
it for configuration file generation.
The LP389 MAC.csv contains most frequently changed parameters as following:
MACAddress: Wellgate LP389 MAC Address
L1tel~l3tel: tel no for each line
L1uid~l3uid: user name for register to SIP proxy for each line
L1pwd~l3pwd: user password for register to SIP proxy for each line
L1dsp~l3dsp: display name for each line
Please save and close it.
Step 2: create a template configuration file
Open the “LP 389 Parameter.txt” getting from Welltech and make the required change. Please at
least make the changes for those provisioning and SIP proxy settings. For detail, please refer the
comments of “LP389 Parameter.txt”.
Step 3: Make the change for wtgencfg.ini as follows if necessary
# Template File
BaseFile=.\LP389 Parameter.txt
# MAC list file
ListFile=.\LP389 MAC.csv
# 0: Off, 1: On
Encrypt=0
26xx Technical Manual EN-V107
Step 4: Generate the individual configuration file.
Double click the “wtgencfg.exe”, it will generate the configuration file for each MAC list in “MAC
address.cfg” as the following pictures.
Step 5:
Put the “*.cfg” file into http or ftp directory. Set the provisioning settings in LP389 and reboot to
test it.
1
/
