Aqua Lung Reflector Kit Installation guide

Aqua Lung
Brand
Aqua Lung
Model
Reflector Kit
Type
Installation guide
0 7
5 3 2 4 2 1 8 0 8 8
PN 427047
Installation Instructions
Re ector Ring
1.
Unscrew valve cap (1).
2.
Place re ector ring (2) over threads (3).
3.
Properly position spring inside valve: Wide end of
end of spring  ts over small boss on valve plate (4)
.
While pulling on cord to keep spring in place,
thread valve cap onto BC.
4.
Fully in ate BC. Test dump valve by pulling on
string. Re-in ate BC. Let stand for 30 minutes.
BC should remain in ated.
Re ector Patch
Note: Re ector patch is normally place above in ator
hold-down. On some smaller BCs, it must be attached
below hold-down
.
1.
Before installing re ector, attach low-pressure
in ator hose (1).
2.
Disconnect in ator hold-down and lift up cor-
rugated hose (2).
3.
Re ector patch is secured with “sandwich-style”
hook & loop attachment. Place re ector against
hose. Wrap inside hook  ap (3) around in ator
hose. Secure loop  ap (4) to hook  ap. Secure
outer hook  ap (5) to loop  ap.
Literature PN 18319, Rev 7/2004
  • Page 1 1
  • Page 2 2

Aqua Lung Reflector Kit Installation guide

Aqua Lung
Brand
Aqua Lung
Model
Reflector Kit
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents