Jeep Baby Traveller Instructions Manual

Brand: Jeep

Model: Baby Traveller

Category: Strollers

Type: Instructions Manual

S67-R1.qxd 1/17/2006 11:30 AM Page 1

Jeep

Baby Traveller

4-Wheel Stroller

Instructions

WARNING

Avoid serious injury from falling or sliding out. Always use Restraint System. Your

child’s safety depends on you. Proper stroller use cannot be assured unless you follow

these instructions. DO NOT USE STROLLER UNTIL YOU READ AND UNDERSTAND THESE

INSTRUCTIONS.

IMPORTANT SAFETY INFORMATION:

HOW TO KEEP YOUR CHILD SAFE WHILE USING THIS STROLLER:

• Assembly by Adult required.

• Never leave your child unattended while in stroller.

Accidents can happen quickly while your back is turned. You must always keep your

child in view while your child is in the stroller, even when sleeping. Do not use this

product as a bed. Your child may become tangled in straps or pads and suocate.

• Always use restraint system system to keep child from standing up or falling out of

the stroller.

• Always lock the stroller open before allowing your child in or near the stroller. This

prevents injuries caused by stroller collapsing.

• Only use this stroller with children who weigh less than 15.8kg. Use by larger

children may damage the stroller, or cause a hazardous unstable condition to exist.

• Use this stroller in the reclined position until child can sit up unassisted.

• Always set the wheel brakes when stroller is not moving, especially on an incline.

This prevents the stroller from rolling away.

• Always fasten the canopy onto the seat back when using the stroller in the reclined

position.

• Put on all brakes whenever you park the stroller.

• Do not carry extra children or bags on this stroller.

• Make sure children are clear of any moving parts if you adjust the stroller, otherwise

they may be injured.

• Do not carry extra children or use accessories other than those approved by the

manufacturer.

WHAT TO AVOID WHILE USING THIS STROLLER:

• Always balance the weight of the stroller evenly. To prevent the stroller from

becoming unstable or tipping:

• Do not place parcels or accessory items on the stroller canopy, seat or over the handle.

• Do not put more than 4.54kg in the basket.

• Do not allow children to play with or hang onto the stroller.

• Never use this stroller on stairways or escalators.

• Do not lift by tray.

• This is not an exercise stroller. Do not use this product while running, jogging, in-line

skating or participating in other athletic activities.

• Do not put child in basket.

• Do not use any car seats with this product. Serious injury could occur.

• Do not use this stroller near an open re or exposed ame.

To Open Stroller

Remove any cardboard inserts or plastic ties

used to protect the product during shipment.

Unfold, making sure both side locks snap into

place as shown.

Parts List

How to Assemble Your Stroller

Stroller Frame Front Wheel

Assembly (2)

Rear Axle AssemblyRear Wheels (2)

Front Tray

Washers (2) C otter Pins (2) Hub C aps (2)

C up Holder

(select models)

Tube

Side Lock

S67-R1.qxd 1/17/2006 11:30 AM Page 4

Infant Head

Roll

To Assemble Rear Wheels

Turn stroller over as shown.

Position rear axle assembly as shown, with red

brake levers pointing towards stroller handle.

Push rear axle assembly onto rear leg tubes

at the same time.

Make sure plastic tabs on rear axle lock into

holes on rear legs as shown.

Slide a wheel onto the axle then slide a

washer onto the axle.

Fit straight part of cotter pin through hole on

axle as shown.

Line up each of the tabs in the hub cap with

the slots in the wheel, snap hub cap into

place.

Repeat for second side.

1 & 2

Tab locks into hole

S67-R1.qxd 1/17/2006 11:30 AM Page 5

To Attach Front Tray

Align tray in holes located on seat frame.

Snap tab in place until a click is heard.

Repeat for second side.

TO RO TATE O R REMO VE TRAY:

Push in

button located near side housing and pull

tray out. Repeat on other side, to remove

tray completely.

To Assemble Front Wheels

Place stroller back on handle bars.

Locate “ ” and “ ” underneath front wheel

assembly. Align assembly with front axle and

snap into place as shown.

Repeat for other wheel. Tug rmly on each

wheel assembly to be sure wheels are

securely in place.

NO TE:

To remove, push spring loaded

button in and pull.

Left

Right

Release Button

S67-R1.qxd 1/17/2006 11:30 AM Page 6

To Attach Cup Holder

Attach cup holder to right handle by aligning

hole over pins and snap into place.

TO C LEAN

: Top rack dishwasher safe.

WARNING

Do not place more than 1 lb (0.45

kg) in this cup holder to avoid

tipping.

Do not place hot liquids in this cup

holder. Hot liquids can burn your

child.

How to Properly Use Your New Stroller

To Operate Brakes

Push levers on both rear wheels down to

lock.

Pull levers up to unlock.

Unlock

Lock

Align plastic seat plug with hole on side

housing, push to snap into place. Repeat for

other side.

To Attach Seat Pad to Frame

S67-R1.qxd 1/17/2006 11:30 AM Page 7

To Secure Child In Stroller

Lock foot brake to keep stroller from rolling.

Place child in stroller.

Hook shoulder straps to waist belt.

To fasten restraint system buckles - push

together. Be sure both buckles are fastened

to secure child safely.

To unsnap restraint system buckles - press

tabs to release.

For proper t, adjust shoulder straps and

waist band as shown.

WARNING

Avoid serious injury from falling or

sliding out. Always use restraint

system.

Adjust Restraint System Harness

S67-R1.qxd 1/17/2006 11:30 AM Page 8

NO TE:

For a secure t, straps should be at or

below the child's shoulder. Adjust straps to

higher position as your child grows.

To readjust shoulder restraints, unbuckle back

of seat and push buckle back through slot.

Position buckle to higher position and push

buckle through slot as shown. Repeat for

second side.

From the back side of the stroller, fasten

buckles together to secure restraint.

To Adjust Shoulder Strap Height

Lower Higher

S67-R1.qxd 1/17/2006 11:30 AM Page 9

To Recline Seat

To recline seat back, loosen belt.

To raise seat back, tighten belt.

WARNING

To avoid nger entrapment or pinching,

do not adjust the seat back while child

is in the stroller. To avoid head

entrapment, always fasten the canopy

to the seat back when using the stroller

in the reclined position.

Tighten

S67-R1.qxd 1/17/2006 11:30 AM Page 10

To Fold Stroller

BEFO RE FO LDIN G

: Lock brakes.

Close canopy.

Pull up latches on frame to fold and push

forward.

Fold as shown.

Engage locking latch.

S67-R1.qxd 1/17/2006 11:30 AM Page 11

There are many ways to look after and protect your Jeep

stroller. The most important is to clean up any spills or food,

before it dries on the fabric.

As the covers are not designed to be easily taken off for washing,

(for safety reasons) the easiest method to clean is, sponge

the surfaces with a mild solution of warm water liquid laundry

detergent. Rinse well with clean sponge and leave to dry out of

direct sun.

Sand and Salt water should be rinsed with a hose and wiped dry

to prolong the life of the wheels, axles and other moving parts.

Never use petroleum based lubricants on your stroller, the most

suitable lubricants are silicone based products.

Jeep

is a registered trademark of DaimlerChrysler Corporation,

Corporation 2007.

Born With Style warrants this product to be free of defects in

materials and workmanship as follows: For a period of ONE

YEAR from the date of purchase, Born With Style will repair

or replace, at its option, the defective product. This warranty is

given in addition to (and not in substitute for) applicable statutory

rights which you may have.

We sincerly thank you for purchasing this Born With Style product.

For further information visit: www.bornwithstyle.com.au

Care and Maintenance

Warranty

S67-R1.qxd 1/17/2006 11:30 AM Page 12

For all spare parts, repairs or warranty issues, please take your product

back to Toys R Us who will contact Karlisles, the service agent on your

behalf.

For spare parts and repairs outside the warranty time please call Karlisles on:

Karlisles

Phone: 1300 308 435

Email: [email protected]

Web: www.karlisles.com.au

Replacement parts provided by local distributor due to accidental

damage or misuse will be charged accordingly.

To contact the manufacturer directly:

Born With Style

PO Box 789

Gladesville NSW 1675, Australia

Phone: 1300 855 337 or 02 9816 3837

Email: [email protected]om.au

Web: www.bornwithstyle.com.au

This product meets and exceeds Australian Standard

AS/NZS 2088:2000

Born With Style recommends that you keep a record of important

information about your Jeep

stroller. Please complete the

information in the space provided.

Model Number:

Date of Manufacture:

Date of Purchase:

No refunds will be given on used product unless assessed by Karlises

as faulty.

Contact Details

Personal Record Card

Jeep Baby Traveller Instructions Manual

Brand: Jeep

Model: Baby Traveller

Category: Strollers

Type: Instructions Manual

Download PDF

report

Jeep Baby Traveller Instructions Manual

Jeep Baby Traveller Instructions Manual

Related papers

Other documents