2. Befaco
  3. 1U STMIX

Befaco 1U STMIX User manual

  • Hello! I'm a chat assistant and I've read the user manual for the Befaco 1U STMIX mixer. This compact four-channel stereo mixer is designed for use alone or as an expansion for the Hexmix module. It features AC-coupled inputs, manual channel attenuation, and compatibility with mono signals. I'm ready to answer any questions you have about its features, connections, or use cases.
  • What is the power polarity?
    Can I connect STMIX to any port at the back of the case?
    What is the output behavior with mono signals?
1U STMIX
U S E R M A N U A L
1 U S T M I X P O W E R & I N T R O
P O W E R I N G T H E
M O D U L E
U S E R M A N U A L
T H A N K S F O R P U R C H A S I N G A M O D U L E F R O M B E FA C O !
B E F O R E Y O U P L U G T H I S M O D U L E I N . . .
1. Disconnect your cabinet from the mains.
2. Triple check the power cord polarity. The coloured line on the cable
(pin number one) is the -12V rail.
3. If you plug the module backwards you might burn it out and
unfortunately this is not covered by the warranty.
4. If you have any questions about this product please send them to:
support@befaco.org
I N T R O D U C T I O N S T M I X
STMix is a four channel stereo mixer in 28hp and 1U format. It can work independently or as expansion of our
Hexmix module via the six pin connector located in the back. The module is designed under the Intellijel 1U
format.
M O D U L E
R E F E R E N C E PA N E L O V E R V I E W
1. Channel's Inputs
Stereo input of each channel. Use the Left input
of each channel for Mono signals. All the inputs
are AC Coupled to maximize audio performance.
2. Channel's knobs
Manual attenuation controls of each channel
input.
3. Output
Main stereo output of the module. When Mono
signals are present on the channels, a duplicate
of those signals will be present on the Right
output
.1
1 U S T M I X F E A T U R E S
F E AT U R E S
U S E R M A N U A L
C O N N E C T I N G T H E U N I T T O H E X M I X
STMix can work as useful submix expansion for Hexmix. Connecting both modules with the
included six pin ribbon cable (X2 port), the output signal of STMix will be present into
Hexmix master section.
Disclaimer: This port is only compatible with Hexmix! Don't connect it to any other port
like the rear Jack connections of our 7U Case.
.2
M I S C E L A N E A S P E C S & C R E D I T S
* Size: 28HP
* Depth: 20mm
* +12v: 30mA
* -12v: 30mA
* Design: Pascual Rocher
/