OMIX LED Tail Light Installation guide

Hello! I've reviewed the installation instructions for the Rugged Ridge Tail Light models 12403.80, 12403.81, and 12403.84. This document details how to replace your Jeep CJ's tail lights with these LED upgrades, including wiring guidance. I'm here to help with any questions you might have regarding the installation process or the specifications detailed in this manual.
What tool might be needed for mounting?

What should you do before starting the installation?

What should you do after installing the tail light?

Installation Instructions

LED Replacement Tail Light 12403.80,12403.81,12403.84

For 46-75 Jeep CJ

- 1 -

NOTE: Because the new LED lights use a larger stud to secure the light assembly, it will be

necessary on some models, to enlarge the existing mounting holes using a 5/16 drill bit and drill.

Step 1: Disconnect the battery.

Step 4: Using a 5/16” drill bit and drill, open

up all mounting holes.

Caution: When drilling, use caution not

to catch any of the wiring

located directly behind the

bod

y panel.

Step 3:

Be careful when pulling the tail

light wiring through the hole.

Disconnect the tail light from the

main wiring.

Step 2: Remove the 2 hex nuts that retain

the tail housing.

Step 5: Wire the tail light using the wiring

code below. Install the tail light and

check for proper function.

/

Other documents