OMIX 12403.84 Installation guide

  • Hello! I'm a chat assistant that has read the Installation Instructions for the Rugged Ridge LED Tail Lights models 12403.80, 12403.81, and 12403.84. This document outlines the steps required to install these lights on 46-75 Jeep CJ models, including drilling and proper wiring. I'm ready to answer any questions you have about this document or the installation process.
  • What is the first step in the installation process?
    What size drill bit is needed for enlarging the mounting holes?
    What is the wiring code for the tail light?
Installation Instructions
LED Replacement Tail Light 12403.80,12403.81,12403.84
For 46-75 Jeep CJ
- 1 -
NOTE: Because the new LED lights use a larger stud to secure the light assembly, it will be
necessary on some models, to enlarge the existing mounting holes using a 5/16 drill bit and drill.
Step 1: Disconnect the battery.
Step 4: Using a 5/16” drill bit and drill, open
up all mounting holes.
Caution: When drilling, use caution not
to catch any of the wiring
located directly behind the
bod
y panel.
Step 3:
Be careful when pulling the tail
light wiring through the hole.
Disconnect the tail light from the
main wiring.
Step 2: Remove the 2 hex nuts that retain
the tail housing.
Step 5: Wire the tail light using the wiring
code below. Install the tail light and
check for proper function.
1/1