2. AGI
  3. A495 UTX Electronic Throttle Controls Kit

AGI A495 UTX Electronic Throttle Controls Kit Owner's manual

  • Hello! I've reviewed the provided installation instructions for the A495 Electronic Throttle Controls Kit. This document includes detailed steps for preparing the control arm, attaching the throttle controls and bottom cover, routing the harness, and installing the ground wire. I'm here to help answer any questions you have about the installation process or features of this kit.
  • What models are compatible with this kit?
    What is the pre-installation step?
    What should I do if control arm does not have the mounting holes?
31133 R0
Revised: MARCH 2021 1
A495
Electronic Throttle Controls Kit
Installation Instructions
Applicable Models:
Westfield, AGI, Hutchinson, Mayrath, and GrainMaxx UTX Series
Pre-Installation Instructions
This step is only required when the mover controls assembly does not have the throttle control mounting holes.
1. Drill five 3/8” holes on each side of the control arm as shown.
1-3/16"
9/16"
1-3/16" 2-1/4" 1-13/16"
15/16"
2 31133 R0
Installing Electronic Throttle Controls Kit
Attaching the Throttle Controls
1Throttle controls 3Locknut, 5/16”
2Bolt, 5/16” x 3/4”
Attaching the Bottom Cover
1Throttle controls bottom cover 3Locknut, 5/16”
2Bolt, 5/16” x 3/4”
1
2
3
1
3
2
A495 ELECTRONIC THROTTLE CONTROLS KIT –
31133 R0 3
Harness Routing
Attaching the Ground Wire Ring Terminal
Routing the Harness
P.O. Box 39
Rosenort, Manitoba, R0G 1W0 Canada Website: www.aggrowth.com
Phone: (866) 467-7207 (Canada & USA) or (204) 746–2396 Email: [email protected]
Fax: (866) 768-4852 ©Ag Growth International Inc. 2021, Printed in Canada
A495 ELECTRONIC THROTTLE CONTROLS KIT –
/