Switching Mode Power Supply
PS30100
PS6050
PS8040
PS10030
-
五.attention
四.instructions
1. When the machine is used as a constant voltage source, turn
the current potentiometer (6) clockwise toMaximum, adjust the
voltage knob (7) to the required voltage value, the stabilized
voltage C. V indicator light is on, and thepressure knob (7) is a
precise multi turn potentiometer, which is convenient to obtain
the accurate voltage value, and the load will be positiveTerminal
output positive terminal (2), load negative terminal output
negative terminal (3), (4) showsOutput voltage value, (5) shows
the output current value, if the current display reaches the rated
valueAnd the C.C indicator light of the side steady current is on,
indicating overload or short circuit at this time, and the negative
should be adjustedLoad, make the machine return to constant
voltage state.
2. When the machine is used as a constant current source, turn
the voltage adjusting knob (7) to the right timeTo adjust the
current (6) to the current required,The current C.C indicator
light is on when the current output is constant. If the constant
voltage C.V indicator light is on, it can be adjustedComplete the
load to make the machine return to constant current state.
1. Reliable output connection line must be used
2. Keep away from heat source as far as possible, keep the
environment dry and fan vent clean
3. No outdoor use
4. When the machine fails, please do not disassemble it without
permission to avoid high voltage electric shock accident
