Waterous SEC. 2317, OPM Operating instructions

Type
Operating instructions
Waterous Company 125 Hardman Avenue South South St. Paul, Minnesota 55075 USA (651) 450-5000
Instructions subject to change without notice.
Operation and
Maintenance Instruction
s
Section
2317
Form No.
F-1031
Issue Date
07/12/02
Rev. Date
02/08/10
Overheat Protection Manager (OPM)
F-1031, Section 2317 Page 1 of 1
Overheat Protection Manager (OPM)
The Overheat Protection Manager (OPM) acts as a safety device by releasā€
ing hot water to the ground or back to the water tank from the discharge area
of the pump. For installation, refer to instruction F-1031, Section 3015.
Maintenance
Check the electrical circuit by pressing the test button located on the panel
plate every 100 hours of pump operation or every six months, whichever
comes first.
If the light does not flash, check all wire connections and re-test. If the light
still does not flash, the light bulb (units built prior to 4/17/2006) or control panel
(units built after 4/17/2006) may need replacement. When optional audible
alarm is used and the test button on the panel is pressed, light will flash but
alarm will not sound. Contact the Waterous Company service department for
repair parts.
  • Page 1 1
  • Page 2 2

Waterous SEC. 2317, OPM Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI